Bernd, Me too, you can filter also my special characters , maybe it's on my default ...
Regards, Scott On Friday, March 20, 2015, Bernd Oppolzer <[email protected]> wrote: > I also found this; seems very good to me: > > https://share.confex.com/share/120/webprogram/Handout/ > Session12981/SHARE%20PDSE%20Best%20Practices.pdf > > Kind regards > > Bernd > > > Am 20.03.2015 um 19:52 schrieb Bernd Oppolzer: > >> what is this? Has this already been covered by the preceeding discussions? >> >> http://www-01.ibm.com/support/knowledgecenter/SSLTBW_1.12.0/ >> com.ibm.zos.r12.idad400/pdsesh.htm%23pdsesh >> >> "Normal or Extended PDSE Sharing" >> >> Kind regards >> >> Bernd >> >> >> Am 20.03.2015 um 17:45 schrieb Henn, Karl: >> >>> Yes, the problem *only* occurs ... >>> >>> ... with z/OS V2R1, >>> ... with PDSEs, >>> ... in case at least one empty member exists in the source PDSE of the >>> copy operation (IEBCOPY), irrespective of how the empty member was created. >>> >>> We do have SMSPDSE and SMSPDSE1 set up and running. >>> >>> "guaranteed synchronous write" was not the culprit. >>> >>> Thanks. >>> >>> Karl >>> >>> -----Original Message----- >>> From: IBM Mainframe Discussion List [mailto:[email protected]] >>> On Behalf Of Bernd Oppolzer >>> Sent: Friday, March 20, 2015 5:10 PM >>> To: [email protected] >>> Subject: Re: Intermittent, not consistently reproducible problems with >>> PDSEs on z/OS V2R1 (incl. infrequent S0F4-20 RSN 1C0752EE ABENDs) >>> >>> Am 20.03.2015 um 17:02 schrieb Henn, Karl: >>> >>>> Have you tried with - directly after each IEBGENER step - do an >>>>> IEBGENER from the member to SYSOUT ? >>>>> >>>> Yes. Makes no difference. Same problem >>>> >>>> Have you tried with only non-empty members? >>>>> >>>> Yes. No empty members - no problem. >>>> >>>> Have tried with DD * instead of DD DATA ? >>>>> >>>> Yes. Makes no difference. Same problem. >>>> >>>> Have you tried with something other than NULLFILE for empty members? >>>>> (E g an IEBCOPY from a third dataset with empty members.) >>>>> >>>> Yes. Makes no difference. Same problem. >>>> >>> that is: >>> >>> the problem is not limited to IEBGENER ... >>> if you build the empty member with other tools, the problem remains? >>> >>> So this is a PDSE problem ... from your posts I'm almost sure that you >>> don't have this problem with normal PDSs. >>> >>> PDSEs are supported by a special address space, AFAIK. Is there a >>> possibility to have site-specific exits installed in the PDSE supporting >>> subsystem; do you have any? >>> >>> Thanks. >>>> >>>> Karl >>>> >>>> ---------------------------------------------------------------------- >>> For IBM-MAIN subscribe / signoff / archive access instructions, send >>> email to [email protected] with the message: INFO IBM-MAIN >>> >>> ---------------------------------------------------------------------- >>> For IBM-MAIN subscribe / signoff / archive access instructions, >>> send email to [email protected] with the message: INFO IBM-MAIN >>> >> >> > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
