So I guess my question, what is the issue? It has the FRRADDR to pass an address of the FRR to get control. What parms do you need to pass to the FRR?
Specifies the name (RS-type), or address in register (2)-(12), of an optional 4 byte input that contains the address of the Functional Recovery Routine (FRR) that is to be established prior to the SRB routine receiving control. The low bit of this address should not be set on. If it is set on, that bit will not be treated as part of the FRR address, but will be treated as indicating SDWALOC31=YES and will override the specification, or default, of SDWALOC31=NO. The FRR receives control in supervisor state, PSW key 0, primary ASC mode, 31-bit addressing mode, holding the same locks the SRB routine held at the time of error. The FRR receives control with the same PASID, SASID, and HASID as the SRB routine had on entry. If you specify LLOCK=YES, then the FRR should release the LOCAL lock prior to the completion of its processing. Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] > On Behalf Of michelbutz > Sent: Sunday, June 14, 2015 11:30 AM > To: [email protected] > Subject: IEAMSCHD no FRR param > > The IEAMSCHD has a FRRADDR parm > But doesn't have an input param for paramters to FRR routine > > Sent from my iPhone > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
