No that big of a deal I'll just prime R13 from the SDWA with the value that the SRB had for 13 Which had my working storage
Sent from my iPhone > On Jun 14, 2015, at 2:41 PM, Lizette Koehler <[email protected]> wrote: > > So I guess my question, what is the issue? > > It has the FRRADDR to pass an address of the FRR to get control. What parms > do you need to pass to the FRR? > > Specifies the name (RS-type), or address in register (2)-(12), of an > optional 4 byte input that contains the address of the Functional Recovery > Routine (FRR) that is to be established prior to the SRB routine receiving > control. The low bit of this address should not be set on. If it is set on, > that bit will not be treated as part of the FRR address, but will be treated > as indicating SDWALOC31=YES and will override the specification, or default, > of SDWALOC31=NO. > > The FRR receives control in supervisor state, PSW key 0, primary ASC mode, > 31-bit addressing mode, holding the same locks the SRB routine held at the > time of error. The FRR receives control with the same PASID, SASID, and > HASID as the SRB routine had on entry. > > If you specify LLOCK=YES, then the FRR should release the LOCAL lock prior > to the completion of its processing. > > > Lizette > > >> -----Original Message----- >> From: IBM Mainframe Discussion List [mailto:[email protected]] >> On Behalf Of michelbutz >> Sent: Sunday, June 14, 2015 11:30 AM >> To: [email protected] >> Subject: IEAMSCHD no FRR param >> >> The IEAMSCHD has a FRRADDR parm >> But doesn't have an input param for paramters to FRR routine >> >> Sent from my iPhone > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
