Hi John,
I don't think that you "need" to IPL in order to implement this change.
You can try changing the VTAMLST definition for the LU named A03AT001.
I am not sure if this is an APPPL definition or NOT. Once changed in VTAMLST,
you can try a V NET,ACT,ID=xxxxxxx,UPDATE=ALL (where 'xxxxxxx' is the Major
node name that contains the A03AT001 definition).
Worst case would be to inact and reactivate that same VTAM Major node!!!
HTH
Tony
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf
Of Jon Bathmaker
Sent: Friday, August 19, 2016 3:18 PM
To: [email protected]
Subject: Re: LOAD VTAM Logmode Table
Hi Elardus,
We are using NVAS. I agree that EMSMODE is an NVAS logmode table.
No IEV043* messages.
I shall get the ops to bounce the Development LPAR on the W/E.
Best regards,
Jon Bathmaker
On 8/19/2016 8:37 AM, Elardus Engelbrecht wrote:
> Jon Bathmaker wrote:
>
>> I am a VTAM usedtobe (in 1995) trying to get VTAM to load a new logmode
>> table, EMSMODE, into its tiny little mind so that I can use a 62x160 screen.
>> I have been able to get it to load the table to my active session with the
>> following command:
>> F
>> NET,TABLE,TYPE=MODETAB,OPTION=ASSOCIATE,NEWTAB=EMSMODE,ID=A03AT001,OL
>> DTAB=* but of course when I log off/on again the modetab is what it
>> was before I issued the command which won't work. I have also tried
>> F NET,TABLE,TYPE=MODETAB,OPTION=LOAD,NEWTAB=EMSMODE which came back
>> OK but did not have the
> desired effect.
>
> NET is dynamic enough that you can do a F NET,blah...
>
> Are you using Netview Access Services or NETVIEW? AFAIK, EMSMODE a Netview
> Access Service Logmode table.
>
> Do you see any IEV043* message?
>
> AFAIK, changes in logmode need a stop/start in Netview Access Service
> accompanied by a V NET,majnode INACT and ACT if needed.
>
> I am not sure how HOD is working, I have never worked with that.
>
> Groete / Greetings
> Elardus Engelbrecht
>
> ----------------------------------------------------------------------
> For IBM-MAIN subscribe / signoff / archive access instructions, send
> email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions, send email to
[email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
