Hello Art, I think $DSPOOL(vvvvvv),UNITDATA would show that information in ATTRIBUTE parm.
------------------------------------------------------------------------------------------------------------------------------- *Lucas Rosalen* [email protected] / [email protected] http://br.linkedin.com/in/lrosalen 2018-05-17 18:15 GMT-03:00 Art Gutowski <[email protected]>: > I've been playing around with $MIGRATE SPOOL, and have had a few degrees > of success, however, on some of our rather archaic systems, I get: > > $HASP003 RC=(136),M 775 > $HASP003 RC=(136),M SPL(vvvvvv) - Command is not allowed on a > $HASP003 target volume with this format. > > This is a MERGE operation...both volumes are ACTIVE. I have read through > the various restrictions, and the messages book. While the plain text is > useful, it falls short of specifying the disallowed format. If I had to > guess, and I don't like to guess, I'd say that my target volume is using > absolute, rather than relative addressing. I have tried migrating to each > available target volume in the configuration, all with the same results. I > would assume therefore, that my source volume is also absolute, and hence a > MOVE operation to a new volume would fail as unceremoniously. > > Is there any way for me to know for certain that these volumes are > absolute, rather than relative? The $DSPOOL,MIGDATA, while useful for > selecting a target with sufficient space, does not provide this > information, and I do not see anything in the SDSF SP display to indicate > addressing mode. > > Follow up question, if I allocate and format a new spool, leaving it > ACTIVE for a MERGE, will it default to absolute addressing like the others, > or will it use relative addressing? I fear offload and COLD start might be > my only way around this mess... > > I am at z/OS 2.2 JES2, $ACTIVATE=z11, LARGEDS=Allowed, CYL_MANAGED=FAIL. > > Thanks, > Art Gutowski > General Motors, LLC > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
