Hello Anne,
Yes that sound right. I take it that you did not CMS FORMAT
the new
Mdisk.
You should be able to do a Q V <cuu> and see the 100 cyl, but
when you do a Q DISK it shows the 400 right?
Ed Martin
Aultman Health Foundation
330-588-4723
[EMAIL PROTECTED]
ext. 40441
>> -----Original Message-----
>> From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED]
On
>> Behalf Of Anne Crabtree
>> Sent: Thursday, April 06, 2006 11:47 AM
>> To: [email protected]
>> Subject: Re: DISKACNT problem
>>
>> Well, the stuff was from a product we demo'd a while back and I don't
>> need it. However, it seems like even though I put 100 cyl in
DISKACNT's
>> 191 A disk, it shows 400 cyl when I query the disk from MAINT. I
assume
>> this is because this particular bit of space was allocated as 400 cyl
for
>> that old product. Does that seem right?
>>
>> >>> [EMAIL PROTECTED] 4/6/2006 10:57 AM >>>
>> You need to run DIRMAP from the CMS 190 disk to make certain that you
>> don't
>> have an overlap somewhere. The easiest way to have DISKACNT "see"
the
>> new
>> disk is to log it off and then after the directory change is done,
log
>> back
>> on to it.
>>
>> Be very careful. You could be writing on top of something else.
>> Jim
>>
>> At 09:52 AM 4/6/2006, you wrote:
>> >I tried to move the DISKACNT A disk to a bigger slot. That area had
>> >previously been used by something else. I issued the FORMAT 191 A
>> command
>> >and discarded the old stuff. The 'area' still has the old label so
I
>> did
>> >FORMAT 191 A (label) and gave it the DSK191 label. I must need to
do
>> >something else, because when I logon as DISKACNT and q disk, it
shows
>> much
>> >more space than I put in the user directory. Do I have to do a
CPFMTXA?
>>
>> Jim Bohnsack
>> Cornell Univ.
>> (607) 255-1760
