It has been awhile but I think JES defines separate transmitters and receivers. RSCS can transmit and receive on the same stream. So, I think you have to define 1 RSCS stream for each transmitter and 1 RSCS stream for each receiver defined in JES just so you don't run into timing conflicts. So, if JES has 2 transmitters and 2 receivers defined you want to define 4 RSCS streams. If JES had all 4 streams active at the same time you want RSCS to be able to handle that much traffic.
Colleen M Brown
IBM z/VM and Related Products Development and Service
| "Les Geer (607-429-3580)"
<[EMAIL PROTECTED]>
Sent by: The IBM z/VM Operating System <[email protected]> 07/04/2006 11:33 PM
|
|
>Sure, I could set this up (maybe tomorrow) . However, a TRACE ... ALL for
>the link for 1.5 mins produced 100000+ lines so it could be big as it can
>take some time before the problem occurs.
>
>I guess you would want the output offlist :-)
>
Yes offlist to lesgeer at IBMUS would be good. Not the entire trace
though, the beginning for link initialization than around the time of
failure.
Best Regards,
Les Geer
IBM z/VM and Linux Development
