I've seen similar results when IPLing a 2nd level z/VM system and the page packs were linked R/O. Sure you have them R/W?
Mike Walter
Hewitt Associates
| "Edward M. Martin"
<[EMAIL PROTECTED]>
Sent by: "The IBM z/VM Operating System" <[email protected]> 07/20/2006 02:06 PM
|
|
Hello Everyone,
We have a z890. z/VM 4.3 and VSE/ESA 2.6.1
We attempting to IPL from the VSE SA utility tape (under z/VM)
I get
MSG HCPCLS174E All Help Information
c) Copyright IBM Corporation 1990, 2002
HCP174E Paging I/O error; IPL failed
Explanation: An I/O error occurred while the system was attempting to read a
page from a direct access storage device.
System Action: The IPL or DIAGNOSE X'64' failed.
User Response: Reissue the IPL or DIAGNOSE X'64' command. If the failure
persists, notify your system operator.
Programmer Response: Resave the segment or system that failed. A possible
cause of the condition is a bad DASD pack. If another DASD pack is available,
use it to retry the IPL. If the problem persists, contact your IBM Support
Center personnel to diagnose and correct the software error.
Can anyone shield some light on this problem?
The z/VM SA DSF/DDR tape works fine.
Ed Martin
Aultman Health Foundation
330-588-4723
[EMAIL PROTECTED]
ext. 40441
The information contained in this e-mail and any accompanying documents may contain information that is confidential or otherwise protected from disclosure. If you are not the intended recipient of this message, or if this message has been addressed to you in error, please immediately alert the sender by reply e-mail and then delete this message, including any attachments. Any dissemination, distribution or other use of the contents of this message by anyone other than the intended recipient is strictly prohibited.
