On Feb 12, 2008 8:17 PM, <[EMAIL PROTECTED]> wrote: > libgen > DEFSEG for LIBDCSST must have previously been issued. > Saved system name is LIBDCSST . . . origin address is 00300000 . . .
The old addresses look like they overlay the CMS nucleus areas... This may be an artefact of very ancient code that uses the wrong Diag64 subcode to find the skeleton. It ends up getting the address of the active segment rather than the skeleton you just prepared. If it did not abend, it would probably save the wrong code in it. If so, the easiest way out is either purge the active DCSS (by spool id) or issue a manual SAVESEG followed by a new DEFSEG for that segment. Both will make the DCSS unusable for your users until you finished the work, if that's a concern. Rob -- Rob van der Heij Velocity Software, Inc http://velocitysoftware.com/
