Using the POF (programmable operatior facility) I would like to user the same
terminal address as the one the Operator came up on when the system was IPL'ed.
I know I can do a CP disconnect after the Operator does a PROPST and then log
on the OP1 user to the same terminal address as the Operator was using and be
able to received messages from the disconnected Operator running PROP and send
command to the Operator via OP1. This currently works and isn't a problem as
the Operator person is doing the CP Disc and then logging OP1.
The issue for me is that the operations management does not want the operator
person to have any interaction with the physical terminal during this
procedure. So, I have to automate the process and I need some suggestions as
how to do this.
The Operator user id has to start PROP and some how run disconnected.
I have to logon OP1 on the same termial to act as the Operator with human
interaction.
I looks easy enough at first but I can't figure out a reasonable way to do this.
Running z/VM 5.3. Any suggestions will be appreciated.
Thanks
_____________
LEGAL NOTICE
Unless expressly stated otherwise, this message is confidential
and may be privileged. It is intended for the addressee(s) only.
Access to this E-mail by anyone else is unauthorized.
If you are not an addressee, any disclosure or copying of the
contents of this E-mail or any action taken (or not taken) in
reliance on it is unauthorized and may be unlawful. If you are not an
addressee, please inform the sender immediately, then delete this
message and empty from your trash.
