I read a little further, and it says use CNSLSCLP to select the line mode HMC console. It doesn't say if the SYSG console is supported, so it probaby isn't.
On Mon, Oct 18, 2010 at 2:32 PM, Michael Coffin <[email protected]> wrote: > Hi Bruce, > > Thanks. I tried CNSLSYSG but no luck with that either. > > Pressing "ENTER" to get the attention of DSF is likewise "not easy". When > PF10 is pressed to LOAD, that causes the X WAIT status on SYSG. ENTER can't > be pressed until SYSG is ready for input. I tried pressing RESET then > CLEAR, and RESET then ENTER - but neither yielded the DSF startup messages. > :( > > -Mike > > -----Original Message----- > From: The IBM z/VM Operating System [mailto:[email protected]] On > Behalf Of Bruce Hayden > Sent: Monday, October 18, 2010 1:58 PM > To: [email protected] > Subject: Re: ICKSADSF Parms > > I think you want CNSLSYSG. ("CNSL" must be the first 4 chars of the > loadparm.) > > On Mon, Oct 18, 2010 at 12:25 PM, Michael Coffin > <[email protected]> wrote: >> Hi Folks, >> >> >> >> I’ve never had an occasion to use ICKSADSF from SALIPL until now (I have a >> clone of my system with NO PAGE or SPOL, so it crashes right after IPL), > so >> I need to allocate a couple of packs. No big deal, I’ll use the > handy-dandy >> ICKSADSF – but whenever I try to use it the load just “stalls”. I imagine >> it can’t find the SYSG console, what is the parm to tell it to use SYSG? >> I’ve tried just “SYSG” and “CONS=SYSG” in the IPL PARMS but neither of > those >> work. >> >> >> >> PS: Is LOAD ORIGIN 1000 OK for ICKSADSF? >> >> >> >> -Mike > > > > -- > Bruce Hayden > z/VM and Linux on System z ATS > IBM, Endicott, NY > -- Bruce Hayden z/VM and Linux on System z ATS IBM, Endicott, NY
