Rob, Most likely you have a 12 volt system.. It would be highly unlikely that anyone would have converted a c-27 to 24 volts.
You can be sure by looking at the back of any device you have on board. It will state the operating Voltage. In fact, the light bulb you are intending to replace .. most probably has the op voltage stamped on it. To check with a voltmeter, simply go to your power panel and measure across any circuit breaker (Positive side) and the common (ground, Negative). With some care not to short circuit, you can measure at any similar point. Such as the Bulb Socket it's self.. Regards, Ralph Ahseln "Oblio" Lying: Portland OR From: RobAdkins Sent: Friday, April 02, 2010 1:08 PM To: [email protected] Subject: [IC27A] electrical enigma hi all, does anyone know if my c27 is a 12 or 24 volt system? where would the test point be if i was to use a volt meter to find out? i'm looking to replace incandescent bulbs with an led system and apparently the system voltage matters a lot. thanks! Rob,
