Thanks - I had verified that as well, neglected to post it.
# service icinga2 checkconfig
* checking Icinga2 configuration
[ OK ]
If it actually failed to start, I should not see a process running at all (and
in this case I do.)
Yes, I did run the DB upgrade manually. All appeared clean. No DB errors on the
master server's logs.
Best regards,
Jay Newman
-----Original Message-----
From: icinga-users [mailto:[email protected]] On Behalf Of
Yann Lehmann
Sent: Thursday, December 31, 2015 11:23 AM
To: Icinga User's Corner <[email protected]>
Subject: Re: [icinga-users] "icinga is not running" after upgrade to r2.4.1-1
Le 31. 12. 15 16:50, Jay Newman a écrit :
> Hello all,
>
> I took advantage of the year-end quiet to upgrade our Icinga2 servers
> from r2.3.10-1 to r2.4.1-1.
>
> Overall it seemed to succeed, though on some nodes apt-get upgrade
> reported it as "held back" but it did upgrade subsequently using aptitude.
>
> The concern I have is that though I see an icinga2 process running,
> "service icinga2 status" reports it as not running.
>
>
I had a similar problem sometimes ago (not a icinga-guru at all).
With the command '/etc/init.d/icinga2 checkconfig', you might find out why it
doesn't start.
In my case, the db-schema was not upgraded "automagically", so I had to do it
"by hand".
See
http://www.monitoring-portal.org/wbb/index.php?page=Thread&threadID=32998
and
http://docs.icinga.org/icinga2/latest/doc/module/icinga2/chapter/upgrading-icinga-2#upgrading-icinga-2
Yann
_______________________________________________
icinga-users mailing list
[email protected]
https://lists.icinga.org/mailman/listinfo/icinga-users
_______________________________________________
icinga-users mailing list
[email protected]
https://lists.icinga.org/mailman/listinfo/icinga-users
