*resolved.*
As a follow-up, I created a new node from scratch. Joined to the cluster in the 
same zone, same options for accepting configuration from the master etc.
This new node does correctly report the icinga2 service as running, so 
something did go astray during the upgrade process.
Not ideal to have to re-install all the satellite nodes, but in this case it 
was an acceptable work-around.

Cheers

-----Original Message-----
From: icinga-users [mailto:[email protected]] On Behalf Of 
Jay Newman
Sent: Thursday, December 31, 2015 11:30 AM
To: Icinga User's Corner <[email protected]>
Subject: Re: [icinga-users] "icinga is not running" after upgrade to r2.4.1-1

Thanks - I had verified that as well, neglected to post it.
# service icinga2 checkconfig
 * checking Icinga2 configuration                                               
                                 [ OK ] 
If it actually failed to start, I should not see a process running at all (and 
in this case I do.) Yes, I did run the DB upgrade manually. All appeared clean. 
No DB errors on the master server's logs.

Best regards,
Jay Newman

-----Original Message-----
From: icinga-users [mailto:[email protected]] On Behalf Of 
Yann Lehmann
Sent: Thursday, December 31, 2015 11:23 AM
To: Icinga User's Corner <[email protected]>
Subject: Re: [icinga-users] "icinga is not running" after upgrade to r2.4.1-1


Le 31. 12. 15 16:50, Jay Newman a écrit :
> Hello all,
>
> I took advantage of the year-end quiet to upgrade our Icinga2 servers 
> from r2.3.10-1 to r2.4.1-1.
>
> Overall it seemed to succeed, though on some nodes apt-get upgrade 
> reported it as "held back" but it did upgrade subsequently using aptitude.
>
> The concern I have is that though I see an icinga2 process running, 
> "service icinga2 status" reports it as not running.
>
>

I had a similar problem sometimes ago (not a icinga-guru at all).

With the command '/etc/init.d/icinga2 checkconfig', you might find out why it 
doesn't start.

In my case, the db-schema was not upgraded "automagically", so I had to do it 
"by hand".

See

http://www.monitoring-portal.org/wbb/index.php?page=Thread&threadID=32998

and

http://docs.icinga.org/icinga2/latest/doc/module/icinga2/chapter/upgrading-icinga-2#upgrading-icinga-2

Yann
_______________________________________________
icinga-users mailing list
[email protected]
https://lists.icinga.org/mailman/listinfo/icinga-users
_______________________________________________
icinga-users mailing list
[email protected]
https://lists.icinga.org/mailman/listinfo/icinga-users
_______________________________________________
icinga-users mailing list
[email protected]
https://lists.icinga.org/mailman/listinfo/icinga-users

Reply via email to