Hi all, what are the significance of increasing numbers in left of lines of output of dmesg?
few sample lines are here [27492.199824] tg3 0000:07:00.0: >eth0: Flow control is off for TX and off for RX [27492.200229] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [33766.669509] tg3 0000:07:00.0: >eth0: Link is down [33773.929450] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [33795.782122] tg3 0000:07:00.0: >eth0: Link is up at 10 Mbps, full duplex [33795.782127] tg3 0000:07:00.0: >eth0: Flow control is off for TX and off for RX [33795.782363] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready and what are these device addresses numbers in left of lines of output of lspci? sample output 00:1f.6 Signal processing controller: Intel Corporation 82801I (ICH9 Family) Thermal Subsystem (rev 03) 04:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g LP-PHY (rev 01) 07:00.0 Ethernet controller: Broadcom Corporation NetLink BCM5906M Fast Ethernet PCI Express (rev 02) what are these addresses(left most numbers)? thank you -- -- Mailing list guidelines and other related articles: http://lug-iitd.org/Footer --- You received this message because you are subscribed to the Google Groups "Linux User Group @ IIT Delhi" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
