There is a hidden POST Server setting in v1.5a that you might find useful.
It was decided that we should leave this setting out of the configurator
because there are only very rare times that you would want to use this.
This setting will cause the entire sent mail to also show up in the POST
Server log file if protocol logging is enabled. You should not enable this
setting normally as your POST Server log file will grow extremely large :-)
Anyway, this setting did not make it into the manual. If you want to set
this you need to use the registry editor as follows:
Open HKLM\\Software\On-Line Data\inFusionMailServer\Post
Create a REG_DWORD entry called ProtocolLogShowData
Set this to 0 to disable or 1 to enable. The POST Server needs to be
restarted for this (or any configuration settings) to take affect.
Regards,
Howie
========================================================================
This list server is Powered by iMS
'The Swiss Army Knife of Mail Servers'
--------------------------------------
To leave this list please complete the form at
http://www.CoolFusion.com/iMS.htm
List archives: http://www.mail-archive.com/infusion-email%40eoscape.com/
========================================================================
