Op 27-11-17 om 10:45 schreef Chris Wilson: > Previously we would enable hotplug polling on the outputs immediately > upon construction. This would allow a very early hotplug event to > trigger before we had finishing setting up the driver to handle it. > Instead, move the output polling to the last step of registration, after > we have set up all handlers, including the fbdev configuration. > > Signed-off-by: Chris Wilson <[email protected]> > Cc: Daniel Vetter <[email protected]> > Cc: Ville Syrjala <[email protected]> > Cc: Maarten Lankhorst <[email protected]> > --- > drivers/gpu/drm/i915/i915_drv.c | 5 +++-- > 1 file changed, 3 insertions(+), 2 deletions(-) > > diff --git a/drivers/gpu/drm/i915/i915_drv.c b/drivers/gpu/drm/i915/i915_drv.c > index 0793a27e2b95..c178cbfdb4c2 100644 > --- a/drivers/gpu/drm/i915/i915_drv.c > +++ b/drivers/gpu/drm/i915/i915_drv.c > @@ -693,8 +693,6 @@ static int i915_load_modeset_init(struct drm_device *dev) > /* Only enable hotplug handling once the fbdev is fully set up. */ > intel_hpd_init(dev_priv); > > - drm_kms_helper_poll_init(dev); > - > return 0; > > cleanup_gem: > @@ -1255,6 +1253,9 @@ static void i915_driver_register(struct > drm_i915_private *dev_priv) > * cannot run before the connectors are registered. > */ > intel_fbdev_initial_config_async(dev); > + > + if (INTEL_INFO(dev_priv)->num_pipes) > + drm_kms_helper_poll_init(dev); > } > > /**
This commit would look better with relevent kernel output pasted in. :) Could this be done before fbdev initial config? Since it's run async, this makes it more clear it is run first. _______________________________________________ Intel-gfx mailing list [email protected] https://lists.freedesktop.org/mailman/listinfo/intel-gfx
