On Thu, Jan 17, 2013 at 12:45:18PM -0800, Ben Widawsky wrote:
> Similar to gtt_mappable_entries we don't usually want the entries,
> it's easy enough to calculate it when you need.
>
> v2: Move relevant fields above pre-gen6 init
>
> Reviewed-by: Rodrigo Vivi <[email protected]>
> Signed-off-by: Ben Widawsky <[email protected]>
[snip]
> @@ -687,11 +690,18 @@ int i915_gem_gtt_init(struct drm_device *dev)
> {
> struct drm_i915_private *dev_priv = dev->dev_private;
> phys_addr_t gtt_bus_addr;
> + u32 gtt_size;
> u16 snb_gmch_ctl;
> int ret;
>
> + if (!pci_set_dma_mask(dev->pdev, DMA_BIT_MASK(40)))
> + pci_set_consistent_dma_mask(dev->pdev, DMA_BIT_MASK(40));
> +
> + pci_read_config_word(dev->pdev, SNB_GMCH_CTRL, &snb_gmch_ctl);
> dev_priv->gtt.mappable_base = pci_resource_start(dev->pdev, 2);
> dev_priv->gtt.mappable_end = pci_resource_len(dev->pdev, 2);
> + gtt_size = gen6_get_total_gtt_size(snb_gmch_ctl);
Calculating gtt size like this doesn't work too well on pre-gen6.
-Daniel
--
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch
_______________________________________________
Intel-gfx mailing list
[email protected]
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
