On 07/01/2019 13:57, Chris Wilson wrote:
Quoting Tvrtko Ursulin (2019-01-07 13:43:29)
On 07/01/2019 11:58, Tvrtko Ursulin wrote:
[snip]
Note about future interaction with preemption: Preemption could happen
in a command sequence prior to watchdog counter getting disabled,
resulting in watchdog being triggered following preemption (e.g. when
watchdog had been enabled in the low priority batch). The driver will
need to explicitly disable the watchdog counter as part of the
preemption sequence.
Does the series take care of preemption?
I did not find that it does.
Oh. I hoped that the watchdog was saved as part of the context... Then
despite preemption, the timeout would resume from where we left off as
soon as it was back on the gpu.
If the timeout remaining was context saved it would be much simpler (at
least on first glance), please say it is.
I made my comments going only by the text from the commit message and
the absence of any preemption special handling.
Having read the spec, the situation seems like this:
* Watchdog control and threshold register are context saved and restored.
* On a context switch watchdog counter is reset to zero and
automatically disabled until enabled by a context restore or explicitly.
So it sounds the commit message could be wrong that special handling is
needed from this direction. But read till the end on the restriction listed.
* Watchdog counter is reset to zero and is not accumulated across
multiple submission of the same context (due preemption).
I read this as - after preemption contexts gets a new full timeout
allocation. Or in other words, if a context is preempted N times, it's
cumulative watchdog timeout will be N * set value.
This could be theoretically exploitable to bypass the timeout. If a
client sets up two contexts with prio -1 and -2, and keeps submitting
periodical no-op batches against prio -1 context, while prio -2 is it's
own hog, then prio -2 context defeats the watchdog timer. I think..
would appreciate is someone challenged this conclusion.
And finally there is one programming restriction which says:
* SW must not preempt the workload which has watchdog enabled. Either
it must:
a) disable preemption for that workload completely, or
b) disable the watchdog via mmio write before any write to ELSP
This seems it contradiction with the statement that the counter gets
disabled on context switch and stays disabled.
I did not spot anything like this in the series. So it would seem the
commit message is correct after all.
It would be good if someone could re-read the bspec text on register
0x2178 to double check what I wrote.
Regards,
Tvrtko
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
