> -----Original Message-----
> From: Imre Deak <[email protected]>
> Sent: Monday, 26 August, 2019 6:42 AM
> To: Souza, Jose <[email protected]>; De Marchi, Lucas
> <[email protected]>; Runyan, Arthur J <[email protected]>
> Cc: [email protected]; Pandiyan, Dhinakaran
> <[email protected]>
> Subject: Re: [Intel-gfx] [PATCH v3 04/23] drm/i915/bdw+: Enable PSR in any
> eDP port
>
> On Fri, Aug 23, 2019 at 01:20:36AM -0700, Lucas De Marchi wrote:
> > From: José Roberto de Souza <[email protected]>
> >
> > From BDW+ the PSR registers moved from DDIA to transcoder, so any port
> > with a eDP panel connected can have PSR, so lets remove this
> > limitation.
> >
> > Cc: Dhinakaran Pandiyan <[email protected]>
> > Cc: Rodrigo Vivi <[email protected]>
> > Signed-off-by: José Roberto de Souza <[email protected]>
> > Signed-off-by: Lucas De Marchi <[email protected]>
> > Reviewed-by: Anshuman Gupta <[email protected]>
> > ---
> > drivers/gpu/drm/i915/display/intel_psr.c | 6 ++----
> > 1 file changed, 2 insertions(+), 4 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/i915/display/intel_psr.c
> b/drivers/gpu/drm/i915/display/intel_psr.c
> > index 81e3619cd905..0172b82858d9 100644
> > --- a/drivers/gpu/drm/i915/display/intel_psr.c
> > +++ b/drivers/gpu/drm/i915/display/intel_psr.c
> > @@ -588,11 +588,9 @@ void intel_psr_compute_config(struct intel_dp
> *intel_dp,
> >
> > /*
> > * HSW spec explicitly says PSR is tied to port A.
> > - * BDW+ platforms have a instance of PSR registers per transcoder but
> > - * for now it only supports one instance of PSR, so lets keep it
> > - * hardcoded to PORT_A
> > + * BDW+ platforms have a instance of PSR registers per transcoder.
> > */
> > - if (dig_port->base.port != PORT_A) {
> > + if (IS_HASWELL(dev_priv) && dig_port->base.port != PORT_A) {
>
> Based on an earlier discussion with Art, before TGL PSR is not supposed
> to be used anywhere else than port A.
>
> Art could you confirm that?
Correct.
PSR1 is limited to DDIA until Tigerlake. There are registers for PSR on the
other
transcoders/ports because of reuse, but hardware isn't fully hooked up or
validated.
PSR2 is still limited to DDIA on Tigerlake.
>
> > DRM_DEBUG_KMS("PSR condition failed: Port not
> supported\n");
> > return;
> > }
> > --
> > 2.23.0
> >
> > _______________________________________________
> > Intel-gfx mailing list
> > [email protected]
> > https://lists.freedesktop.org/mailman/listinfo/intel-gfx
_______________________________________________
Intel-gfx mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
