> -----Original Message-----
> From: Intel-gfx <[email protected]> On Behalf Of Jani
> Nikula
> Sent: Thursday, February 11, 2021 8:22 PM
> To: [email protected]
> Cc: Nikula, Jani <[email protected]>; Varide, Nischal
> <[email protected]>
> Subject: [Intel-gfx] [PATCH v3 9/9] drm/i915/edp: enable eDP MSO during link
> training
>
> If the source and sink support MSO, enable it during link training.
>
> v3: Adjust timings, refer to splitter
Changes Look Good to me.
Reviewed-by: Uma Shankar <[email protected]>
> v2: Limit MSO to pipe A using ->pipe_mask
>
> Cc: Nischal Varide <[email protected]>
> Signed-off-by: Jani Nikula <[email protected]>
> ---
> drivers/gpu/drm/i915/display/intel_ddi.c | 37 ++++++++++++++++++++
> drivers/gpu/drm/i915/display/intel_display.c | 13 +++++++
> drivers/gpu/drm/i915/display/intel_dp.c | 34 ++++++++++++++++--
> 3 files changed, 82 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_ddi.c
> b/drivers/gpu/drm/i915/display/intel_ddi.c
> index c9098297b6ac..5a8d1abd208a 100644
> --- a/drivers/gpu/drm/i915/display/intel_ddi.c
> +++ b/drivers/gpu/drm/i915/display/intel_ddi.c
> @@ -2167,6 +2167,34 @@ static void intel_ddi_mso_get_config(struct
> intel_encoder *encoder,
> pipe_config->splitter.pixel_overlap =
> REG_FIELD_GET(OVERLAP_PIXELS_MASK, dss1); }
>
> +static void intel_ddi_mso_configure(const struct intel_crtc_state
> +*crtc_state) {
> + struct intel_crtc *crtc = to_intel_crtc(crtc_state->uapi.crtc);
> + struct drm_i915_private *i915 = to_i915(crtc->base.dev);
> + enum pipe pipe = crtc->pipe;
> + u32 dss1 = 0;
> +
> + if (!HAS_MSO(i915))
> + return;
> +
> + if (crtc_state->splitter.enable) {
> + /* Splitter enable is supported for pipe A only. */
> + if (drm_WARN_ON(&i915->drm, pipe != PIPE_A))
> + return;
> +
> + dss1 |= SPLITTER_ENABLE;
> + dss1 |= OVERLAP_PIXELS(crtc_state->splitter.pixel_overlap);
> + if (crtc_state->splitter.link_count == 2)
> + dss1 |= SPLITTER_CONFIGURATION_2_SEGMENT;
> + else
> + dss1 |= SPLITTER_CONFIGURATION_4_SEGMENT;
> + }
> +
> + intel_de_rmw(i915, ICL_PIPE_DSS_CTL1(pipe),
> + SPLITTER_ENABLE | SPLITTER_CONFIGURATION_MASK |
> + OVERLAP_PIXELS_MASK, dss1);
> +}
> +
> static void tgl_ddi_pre_enable_dp(struct intel_atomic_state *state,
> struct intel_encoder *encoder,
> const struct intel_crtc_state *crtc_state, @@
> -
> 2260,6 +2288,11 @@ static void tgl_ddi_pre_enable_dp(struct intel_atomic_state
> *state,
> */
> intel_ddi_power_up_lanes(encoder, crtc_state);
>
> + /*
> + * 7.g Program CoG/MSO configuration bits in DSS_CTL1 if selected.
> + */
> + intel_ddi_mso_configure(crtc_state);
> +
> /*
> * 7.g Configure and enable DDI_BUF_CTL
> * 7.h Wait for DDI_BUF_CTL DDI Idle Status = 0b (Not Idle), timeout @@
> -
> 4143,6 +4176,10 @@ void intel_ddi_init(struct drm_i915_private *dev_priv, enum
> port port)
> goto err;
>
> dig_port->hpd_pulse = intel_dp_hpd_pulse;
> +
> + /* Splitter enable for eDP MSO is supported for pipe A only. */
> + if (dig_port->dp.mso_link_count)
> + encoder->pipe_mask = BIT(PIPE_A);
> }
>
> /* In theory we don't need the encoder->type check, but leave it just
> in diff -
> -git a/drivers/gpu/drm/i915/display/intel_display.c
> b/drivers/gpu/drm/i915/display/intel_display.c
> index 3059a07b8c36..06b7edbe1187 100644
> --- a/drivers/gpu/drm/i915/display/intel_display.c
> +++ b/drivers/gpu/drm/i915/display/intel_display.c
> @@ -4917,6 +4917,19 @@ static int intel_crtc_compute_config(struct intel_crtc
> *crtc,
> pipe_config->pipe_src_w /= 2;
> }
>
> + if (pipe_config->splitter.enable) {
> + int n = pipe_config->splitter.link_count;
> + int overlap = pipe_config->splitter.pixel_overlap;
> +
> + pipe_mode->crtc_hdisplay = (pipe_mode->crtc_hdisplay - overlap)
> *
> n;
> + pipe_mode->crtc_hblank_start = (pipe_mode->crtc_hblank_start -
> overlap) * n;
> + pipe_mode->crtc_hblank_end = (pipe_mode->crtc_hblank_end -
> overlap) * n;
> + pipe_mode->crtc_hsync_start = (pipe_mode->crtc_hsync_start -
> overlap) * n;
> + pipe_mode->crtc_hsync_end = (pipe_mode->crtc_hsync_end -
> overlap) * n;
> + pipe_mode->crtc_htotal = (pipe_mode->crtc_htotal - overlap) * n;
> + pipe_mode->crtc_clock *= n;
> + }
> +
> intel_mode_from_crtc_timings(pipe_mode, pipe_mode);
>
> if (INTEL_GEN(dev_priv) < 4) {
> diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
> b/drivers/gpu/drm/i915/display/intel_dp.c
> index 5d5b16f70ed2..8f39da994d14 100644
> --- a/drivers/gpu/drm/i915/display/intel_dp.c
> +++ b/drivers/gpu/drm/i915/display/intel_dp.c
> @@ -1745,6 +1745,10 @@ intel_dp_drrs_compute_config(struct intel_dp *intel_dp,
> intel_connector->panel.downclock_mode->clock,
> pipe_config->port_clock, &pipe_config->dp_m2_n2,
> constant_n, pipe_config->fec_enable);
> +
> + /* FIXME: abstract this better */
> + if (pipe_config->splitter.enable)
> + pipe_config->dp_m2_n2.gmch_m *= pipe_config-
> >splitter.link_count;
> }
>
> int
> @@ -1819,6 +1823,26 @@ intel_dp_compute_config(struct intel_encoder
> *encoder,
> output_bpp = intel_dp_output_bpp(pipe_config->output_format,
> pipe_config->pipe_bpp);
>
> + if (intel_dp->mso_link_count) {
> + int n = intel_dp->mso_link_count;
> + int overlap = intel_dp->mso_pixel_overlap;
> +
> + pipe_config->splitter.enable = true;
> + pipe_config->splitter.link_count = n;
> + pipe_config->splitter.pixel_overlap = overlap;
> +
> + drm_dbg_kms(&dev_priv->drm, "MSO link count %d, pixel overlap
> %d\n",
> + n, overlap);
> +
> + adjusted_mode->crtc_hdisplay = adjusted_mode->crtc_hdisplay / n
> + overlap;
> + adjusted_mode->crtc_hblank_start = adjusted_mode-
> >crtc_hblank_start / n + overlap;
> + adjusted_mode->crtc_hblank_end = adjusted_mode-
> >crtc_hblank_end / n + overlap;
> + adjusted_mode->crtc_hsync_start = adjusted_mode-
> >crtc_hsync_start / n + overlap;
> + adjusted_mode->crtc_hsync_end = adjusted_mode-
> >crtc_hsync_end / n + overlap;
> + adjusted_mode->crtc_htotal = adjusted_mode->crtc_htotal / n +
> overlap;
> + adjusted_mode->crtc_clock /= n;
> + }
> +
> intel_link_compute_m_n(output_bpp,
> pipe_config->lane_count,
> adjusted_mode->crtc_clock,
> @@ -1826,6 +1850,10 @@ intel_dp_compute_config(struct intel_encoder
> *encoder,
> &pipe_config->dp_m_n,
> constant_n, pipe_config->fec_enable);
>
> + /* FIXME: abstract this better */
> + if (pipe_config->splitter.enable)
> + pipe_config->dp_m_n.gmch_m *= pipe_config->splitter.link_count;
> +
> if (!HAS_DDI(dev_priv))
> intel_dp_set_clock(encoder, pipe_config);
>
> @@ -3564,8 +3592,10 @@ static void intel_edp_mso_init(struct intel_dp
> *intel_dp)
> if (mso) {
> drm_dbg_kms(&i915->drm, "Sink MSO %ux%u configuration\n",
> mso, drm_dp_max_lane_count(intel_dp->dpcd) / mso);
> - drm_err(&i915->drm, "No source MSO support, disabling\n");
> - mso = 0;
> + if (!HAS_MSO(i915)) {
> + drm_err(&i915->drm, "No source MSO support,
> disabling\n");
> + mso = 0;
> + }
> }
>
> intel_dp->mso_link_count = mso;
> --
> 2.20.1
>
> _______________________________________________
> Intel-gfx mailing list
> [email protected]
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx
_______________________________________________
Intel-gfx mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
