The existing code (which I changed last) was very convoluted. I believe it was attempting to skip the overclock portion if the previous pcode write failed. When I last touched the code, I was preserving this behavior. There is some benefit to doing it that way in that if the first pcode access fails, the later is likely invalid.
Having a bit more confidence in my understanding of how things work, I now feel it's better to have clear, readable, code than to try to skip over this one operation in an unusual case. Signed-off-by: Ben Widawsky <[email protected]> --- drivers/gpu/drm/i915/intel_pm.c | 20 +++++++++----------- 1 file changed, 9 insertions(+), 11 deletions(-) diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c index a6b877a..66172b6 100644 --- a/drivers/gpu/drm/i915/intel_pm.c +++ b/drivers/gpu/drm/i915/intel_pm.c @@ -3323,7 +3323,7 @@ static void gen6_enable_rps(struct drm_device *dev) struct intel_ring_buffer *ring; u32 rp_state_cap, hw_max, hw_min; u32 gt_perf_status; - u32 rc6vids, pcu_mbox, rc6_mask = 0; + u32 rc6vids, pcu_mbox = 0, rc6_mask = 0; u32 gtfifodbg; int rc6_mode; int i, ret; @@ -3411,17 +3411,15 @@ static void gen6_enable_rps(struct drm_device *dev) I915_WRITE(GEN6_RP_IDLE_HYSTERSIS, 10); ret = sandybridge_pcode_write(dev_priv, GEN6_PCODE_WRITE_MIN_FREQ_TABLE, 0); - if (!ret) { - pcu_mbox = 0; - ret = sandybridge_pcode_read(dev_priv, GEN6_READ_OC_PARAMS, &pcu_mbox); - if (!ret && (pcu_mbox & (1<<31))) { /* OC supported */ - DRM_DEBUG_DRIVER("Overclocking supported. Max: %dMHz, Overclock max: %dMHz\n", - (dev_priv->rps.max_delay & 0xff) * 50, - (pcu_mbox & 0xff) * 50); - dev_priv->rps.hw_max = pcu_mbox & 0xff; - } - } else { + if (ret) DRM_DEBUG_DRIVER("Failed to set the min frequency\n"); + + ret = sandybridge_pcode_read(dev_priv, GEN6_READ_OC_PARAMS, &pcu_mbox); + if (!ret && (pcu_mbox & (1<<31))) { /* OC supported */ + DRM_DEBUG_DRIVER("Overclocking supported. Max: %dMHz, Overclock max: %dMHz\n", + (dev_priv->rps.max_delay & 0xff) * 50, + (pcu_mbox & 0xff) * 50); + dev_priv->rps.hw_max = pcu_mbox & 0xff; } dev_priv->rps.power = HIGH_POWER; /* force a reset */ -- 1.8.5.5 _______________________________________________ Intel-gfx mailing list [email protected] http://lists.freedesktop.org/mailman/listinfo/intel-gfx
