On 11 Dec 2015 7:09 PM, "Durgadoss R" <[email protected]> wrote: > > To support USB type C alternate DP mode, the display driver needs to > know the number of lanes required by the DP panel as well as number > of lanes that can be supported by the type-C cable. Sometimes, the > type-C cable may limit the bandwidth even if Panel can support > more lanes. To address these scenarios, the display driver will > start link training with max lanes, and if that fails, the driver > falls back to x2 lanes; and repeats this procedure for all > bandwidth/lane configurations. > > * Since link training is done before modeset only the port > (and not pipe/planes) and its associated PLLs are enabled. > * On DP hotplug: Directly start link training on the crtc > associated with the DP encoder. > * On Connected boot scenarios: When booted with an LFP and a DP, > typically, BIOS brings up DP. In these cases, we disable the > crtc, do upfront link training and then re-enable it back. > * All local changes made for upfront link training are reset > to their previous values once it is done; so that the > subsequent modeset is not aware of these changes.
This is just an aside but do we know if other OSes just always link train at plug time. I do wonder if we should make an OS level decision to require driver do this always. Dave. > > Signed-off-by: Durgadoss R <[email protected]> > --- > drivers/gpu/drm/i915/intel_ddi.c | 81 ++++++++++++++++++++++++++++++++++++++++ > drivers/gpu/drm/i915/intel_dp.c | 77 +++++++++++++++++++++++++++++++++++++- > drivers/gpu/drm/i915/intel_drv.h | 2 + > 3 files changed, 159 insertions(+), 1 deletion(-) > > diff --git a/drivers/gpu/drm/i915/intel_ddi.c b/drivers/gpu/drm/i915/intel_ddi.c > index 632044a..43efc26 100644 > --- a/drivers/gpu/drm/i915/intel_ddi.c > +++ b/drivers/gpu/drm/i915/intel_ddi.c > @@ -3274,6 +3274,87 @@ intel_ddi_init_hdmi_connector(struct intel_digital_port *intel_dig_port) > return connector; > } > > +bool intel_ddi_upfront_link_train(struct intel_dp *intel_dp, > + struct intel_crtc *crtc) > +{ > + struct intel_digital_port *dig_port = dp_to_dig_port(intel_dp); > + struct intel_connector *connector = intel_dp->attached_connector; > + struct intel_encoder *encoder = connector->encoder; > + struct drm_device *dev = encoder->base.dev; > + struct drm_i915_private *dev_priv = dev->dev_private; > + struct intel_shared_dpll *pll; > + struct drm_crtc *drm_crtc = NULL; > + struct intel_crtc_state *tmp_crtc_config; > + struct intel_dpll_hw_state tmp_dpll_hw_state; > + uint8_t link_bw, lane_count; > + > + if (!crtc) { > + drm_crtc = intel_get_unused_crtc(&encoder->base); > + if (!drm_crtc) { > + DRM_ERROR("No crtc for upfront link training\n"); > + return false; > + } > + encoder->base.crtc = drm_crtc; > + crtc = to_intel_crtc(drm_crtc); > + } > + > + /* Initialize with Max Link rate & lane count supported by panel */ > + link_bw = intel_dp->dpcd[DP_MAX_LINK_RATE]; > + lane_count = drm_dp_max_lane_count(intel_dp->dpcd); > + > + /* Save the crtc->config */ > + tmp_crtc_config = crtc->config; > + tmp_dpll_hw_state = crtc->config->dpll_hw_state; > + > + /* Select the shared DPLL to use for this port */ > + intel_get_ddi_pll(dev_priv, dig_port->port, crtc->config); > + pll = intel_crtc_to_shared_dpll(crtc); > + if (!pll) { > + DRM_ERROR("Could not get shared DPLL\n"); > + goto exit; > + } > + DRM_DEBUG_KMS("Using %s for pipe %c\n", pll->name, pipe_name(crtc->pipe)); > + > + do { > + crtc->config->port_clock = drm_dp_bw_code_to_link_rate(link_bw); > + crtc->config->lane_count = lane_count; > + if (!intel_ddi_pll_select(crtc, crtc->config, encoder, false)) > + goto exit; > + > + pll->config.crtc_mask |= (1 << crtc->pipe); > + pll->config.hw_state = crtc->config->dpll_hw_state; > + > + /* Enable PLL followed by port */ > + intel_enable_shared_dpll(crtc); > + encoder->pre_enable(encoder); > + > + /* Check if link training passed; if so update DPCD */ > + if (intel_dp->train_set_valid) > + intel_dp_update_dpcd_params(intel_dp); > + > + /* Disable port followed by PLL for next retry/clean up */ > + encoder->post_disable(encoder); > + intel_disable_shared_dpll(crtc); > + > + } while (!intel_dp->train_set_valid && > + !intel_dp_get_link_retry_params(&lane_count, &link_bw)); > + > + /* Reset pll state as before */ > + pll->config.crtc_mask &= ~(1 << crtc->pipe); > + pll->config.hw_state = tmp_dpll_hw_state; > + > +exit: > + /* Reset local associations made */ > + if (drm_crtc) > + encoder->base.crtc = NULL; > + crtc->config = tmp_crtc_config; > + > + DRM_DEBUG_KMS("Upfront link train %s: lanes:%d bw:%d\n", > + intel_dp->train_set_valid ? "Passed" : "Failed", lane_count, link_bw); > + > + return intel_dp->train_set_valid; > +} > + > void intel_ddi_init(struct drm_device *dev, enum port port) > { > struct drm_i915_private *dev_priv = dev->dev_private; > diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c > index d8f7830..47b6266 100644 > --- a/drivers/gpu/drm/i915/intel_dp.c > +++ b/drivers/gpu/drm/i915/intel_dp.c > @@ -4622,6 +4622,71 @@ intel_dp_unset_edid(struct intel_dp *intel_dp) > intel_dp->has_audio = false; > } > > +static void intel_dp_upfront_dpms_off(struct drm_connector *connector, > + struct drm_modeset_acquire_ctx *ctx) > +{ > + struct intel_dp *intel_dp = intel_attached_dp(connector); > + struct intel_digital_port *intel_dig_port = dp_to_dig_port(intel_dp); > + struct drm_crtc *crtc = intel_dig_port->base.base.crtc; > + struct intel_load_detect_pipe tmp; > + > + if (intel_get_load_detect_pipe(connector, NULL, &tmp, ctx)) { > + crtc->acquire_ctx = ctx; > + tmp.dpms_mode = DRM_MODE_DPMS_OFF; > + intel_release_load_detect_pipe(connector, &tmp, ctx); > + } > +} > + > +static void intel_dp_upfront_dpms_on(struct drm_connector *connector, > + struct drm_modeset_acquire_ctx *ctx) > +{ > + struct intel_load_detect_pipe tmp; > + > + intel_get_load_detect_pipe(connector, NULL, &tmp, ctx); > + > + drm_modeset_drop_locks(ctx); > + drm_modeset_acquire_fini(ctx); > +} > + > +static bool intel_dp_upfront_link_train(struct drm_connector *connector) > +{ > + struct intel_dp *intel_dp = intel_attached_dp(connector); > + struct intel_digital_port *intel_dig_port = dp_to_dig_port(intel_dp); > + struct intel_encoder *intel_encoder = &intel_dig_port->base; > + struct drm_device *dev = intel_encoder->base.dev; > + struct drm_crtc *crtc = intel_dig_port->base.base.crtc; > + struct intel_crtc *intel_crtc = crtc ? to_intel_crtc(crtc) : NULL; > + struct drm_modeset_acquire_ctx ctx, *old_ctx = NULL; > + bool ret = true, need_dpms_on = false; > + > + if (!IS_BROXTON(dev)) > + return true; > + /* > + * On hotplug cases, we call _upfront_link_train directly. > + * In connected boot scenarios (boot with {MIPI/eDP} + DP), > + * BIOS typically brings up DP. Hence, we disable the crtc > + * to do _upfront_link_training and then re-enable it back. > + */ > + if (crtc && crtc->enabled && intel_crtc->active) { > + DRM_DEBUG_KMS("Disabling pipe %c\n", pipe_name(intel_crtc->pipe)); > + old_ctx = crtc->acquire_ctx; > + drm_modeset_acquire_init(&ctx, 0); > + intel_dp_upfront_dpms_off(connector, &ctx); > + need_dpms_on = true; > + } > + > + if (HAS_DDI(dev)) > + ret = intel_ddi_upfront_link_train(intel_dp, intel_crtc); > + /* Other platforms upfront link train call goes here..*/ > + > + if (need_dpms_on) { > + intel_dp_upfront_dpms_on(connector, &ctx); > + crtc->acquire_ctx = old_ctx; > + } > + return ret; > +} > + > + > static enum drm_connector_status > intel_dp_detect(struct drm_connector *connector, bool force) > { > @@ -4631,7 +4696,7 @@ intel_dp_detect(struct drm_connector *connector, bool force) > struct drm_device *dev = connector->dev; > enum drm_connector_status status; > enum intel_display_power_domain power_domain; > - bool ret; > + bool ret, do_upfront_link_train; > u8 sink_irq_vector; > > DRM_DEBUG_KMS("[CONNECTOR:%d:%s]\n", > @@ -4705,6 +4770,16 @@ intel_dp_detect(struct drm_connector *connector, bool force) > DRM_DEBUG_DRIVER("CP or sink specific irq unhandled\n"); > } > > + /* Do not do upfront link train, if it is a compliance request */ > + do_upfront_link_train = > + intel_encoder->type == INTEL_OUTPUT_DISPLAYPORT && > + intel_dp->compliance_test_type != DP_TEST_LINK_TRAINING; > + > + if (do_upfront_link_train) { > + ret = intel_dp_upfront_link_train(connector); > + if (!ret) > + status = connector_status_disconnected; > + } > out: > intel_display_power_put(to_i915(dev), power_domain); > return status; > diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h > index 5912955..3cfab20 100644 > --- a/drivers/gpu/drm/i915/intel_drv.h > +++ b/drivers/gpu/drm/i915/intel_drv.h > @@ -1025,6 +1025,8 @@ void intel_ddi_clock_get(struct intel_encoder *encoder, > struct intel_crtc_state *pipe_config); > void intel_ddi_set_vc_payload_alloc(struct drm_crtc *crtc, bool state); > uint32_t ddi_signal_levels(struct intel_dp *intel_dp); > +bool intel_ddi_upfront_link_train(struct intel_dp *intel_dp, > + struct intel_crtc *crtc); > > /* intel_frontbuffer.c */ > void intel_fb_obj_invalidate(struct drm_i915_gem_object *obj, > -- > 1.9.1 > > _______________________________________________ > Intel-gfx mailing list > [email protected] > http://lists.freedesktop.org/mailman/listinfo/intel-gfx
_______________________________________________ Intel-gfx mailing list [email protected] http://lists.freedesktop.org/mailman/listinfo/intel-gfx
