I created some probes for PowerConnect W-3600 based of their MIBS. These are
Aruba wireless controllers rebranded as Dell. Has anyone created probes for
the Aruba/Dell wireless ap and controllers and gotten data from the tables? The
probe I've created is based off firmware 6.1.2.2 and imported both mib and new
probe into server. The probe connects and displays the basic information for
Device Status, but clicking on any of the Table links opens windows that have
no information. This is what I see below when I open the status on the
wireless controller.
I'm looking for tips if I'm not using the Probe Builder properly.
Device Status
Name: XXXXXXXX
DNS Name: XXXXXXXX
Address: XXXXXX
Status: UP
Probe: WLSR-AP-MIB Viewer (port 161 SNMPv2c)
Up Time: 8 hours, 21 minutes, 55 seconds
SysName: XXXXXXX
Contact: XXXXXX
Location: XXXXXX
Availability: 100 % (of 56 minutes, 45 seconds)
Packet Loss: 0.0 % (of 19 total attempts)
Short-term Packet Loss: 0.0 % (of 19 last attempts) [Reset]
Recent Loss: None
Response time: 1 msec
WLSR-AP-MIB Viewer
No variables defined
Tables from WLSR-AP-MIB
View the wlsrConfigTable
View the wlsrChannelStatsTable
View the wlsrChannelRateStatsTable
View the wlsrChannelDATypeStatsTable
View the wlsrChannelFrameTypeStatsTable
View the wlsrChannelPktSizeStatsTable
View the wlsrStaStatsTable
View the wlsrStaRateStatsTable
View the wlsrStaDATypeStatsTable
View the wlsrStaFrameTypeStatsTable
View the wlsrStaPktSizeStatsTable
View the wlsrAirMonitorApListTable
Last updated Dec 06, 13:28:14; interval: 5 minutes, 0 seconds
____________________________________________________________________
List archives:
http://www.mail-archive.com/intermapper-talk%40list.dartware.com/
To unsubscribe: send email to: [email protected]
