Will update asap and test. I updated to V5.01 yesterday, and I had a few problems. Just though I should point them out quickly in case you would see something similar on your side. (I have not had time to debug them more in detail.)
1. Connection to IOIO seems only to be established if IOIO chip is started befor the App. (My app is based on the IOIOService example). 2. After aprox two hours connection was dropped. (Samsung Galaxy 4, USB connection, IOIOAccessoryLib used, power submitted with a 12V, 3A poweradapter) - and not established. 3. TWIMaster api runs fine, but suddenly stops sending/receiving data. I powercycled the i2c chip to make sure it did not hang without any result. As the twi.writeRead blocks until a response is returned I run the The twi.writeRead command in a separate thread and interrupt it if no answer is returned within 5 sec. But once this problem occurs, there is no way to recover but to rerun the Application. Would any of these problems be affected by the Sequencerfix that you mention in the 5.02 release? //Thomas Den onsdagen den 22:e januari 2014 kl. 06:33:12 UTC+1 skrev Ytai: > > Sorry for the blast folks :) > Still fixing some little bugs as result of the major changes in v5. > > If you're using v5.x, please update your IOIOLib to v5.02. No firmware > change necessary. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/groups/opt_out.
