Are you using the bare sensor or a breakout board that has a few more components on it? If that latter, please send a product page link or, even better, a schematic.
On Tue, Apr 1, 2014 at 1:37 PM, Marius Vosylius <[email protected]>wrote: > Dear Ytai, I have followed these steps and able to output V out. Heres a >> picture of my code below: >> > > > <https://lh4.googleusercontent.com/-q97pzmVV1q4/UzsjMrTChCI/AAAAAAAAHps/czg42ZZhKJo/s1600/Screen+Shot+2014-04-01+at+21.34.25.png> > My V Outpout is: 2.8 - 3.0 V > Reading Output is: 0.87 - 1. > > Please advise me what else do I need to do to get Gas MQ2 Reading. Thanks. > > -- > You received this message because you are subscribed to the Google Groups > "ioio-users" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/ioio-users. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
