Here's the process. I hooked up the board to a 5v adapter after connecting boot pin to Gnd and pin1 to Gnd simultaneously. I observed the stat led flash rapidly, I then disconnected everything jumpered boot pin to gnd and connected via usb cable to linux box.
For the second test I repeated the reset process but connected the board as is without anything jumpered. Don't think there was any merit in this test but I did it anyway and linux identified device properly. I was thinking if there is absolutely no difference in the code that establishes the handshake to the PC then maybe somehow the timing of manually removing the boot pin jumper by hand after connection is causing an issue. I'm going to try another test where I put the board into boot loader mode using the 5v adapter, remove the jumper and then connect the usb cable while the wall charger keeps the board awake. -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
