Good idea! Let me know how that goes. On May 20, 2014 10:00 AM, "Mark z" <[email protected]> wrote:
> Here's the process. I hooked up the board to a 5v adapter after connecting > boot pin to Gnd and pin1 to Gnd simultaneously. I observed the stat led > flash rapidly, I then disconnected everything jumpered boot pin to gnd and > connected via usb cable to linux box. > > For the second test I repeated the reset process but connected the board > as is without anything jumpered. Don't think there was any merit in this > test but I did it anyway and linux identified device properly. > > I was thinking if there is absolutely no difference in the code that > establishes the handshake to the PC then maybe somehow the timing of > manually removing the boot pin jumper by hand after connection is causing > an issue. I'm going to try another test where I put the board into boot > loader mode using the 5v adapter, remove the jumper and then connect the > usb cable while the wall charger keeps the board awake. > > -- > You received this message because you are subscribed to the Google Groups > "ioio-users" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/ioio-users. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
