Team I think I just 'fried' three ioio boards in one evening. I have been working with these for over 6 months and never had a problem. But i was working on "lab settings" and and we were testing our programs
Today I tried to connect and disconnect multiple times to make sure my program was working and RIGHT as i was connecting or disconnecting the tablet the devices powered OFF and I have not been able to power them on. Also while connecting and disconnecting it was fine the few times but then power off. Few more info 1) I was originally connecting wires to VIn and GND and connecting it to a 5v wall charger (or to a laptop 5v). I blew two of them on this setup. I thought the wires shorted 2) Next I used the JST connector and gave it 12 v (again from wall charger) and didnt use any "naked" wires. After connecting and disconnecting a tablet a few time this blew up too. 3) Board is connected to tablet using the Red USB wire from sparkfun Best Regards RK -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
