Did you remember pull up resistors on the bus? On Oct 16, 2015 8:50 AM, "Tyler Trombetta" <[email protected]> wrote:
> I went back and re-read the data sheet more thoroughly, and it appears I > was wrong. I just found the example on page 18 that details how to take a > single measurement. Looking at your first post, I see that's where your > code comes from. I now think you did everything right, except for waiting 6 > ms for the data to be placed into the data registers. > > So, I would revert back to your first code attempt, but place the line: > Thread.sleep(6); > after writeRead() command #2, to have the IOIO wait 6 ms for the data to > be available. Then you should be able to properly read the data. > > It can't hurt to write to the configuration registers before the > measurement (as in the example), so I would recommend that as well. Sorry > to lead you down the wrong trail. > > Tyler > > -- > You received this message because you are subscribed to the Google Groups > "ioio-users" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/ioio-users. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
