Hi Massimo,
If you refer to table 20.2 in ipmi specification v2.0, it is mentioned that
user should not depend on response of the command.
Cold reset command resets the communication, event and sensor functions.
So could you check if sensor or communication has been reinitialized?
If yes, then it means , it works fine.
Regards
Amit
On Thu, 13 Dec 2007 Massimo Gaggero wrote :
>Ok, If I try the command:
># ipmitool -v raw 0x6 0x2
>RAW REQ (channel=0x0 netfn=0x6 lun=0x0 cmd=0x2 data_len=0)
>RAW RSP (0 bytes)
>
>#
>it returns a blank line... not good, I suppose...
>
>Massimo.
>
>
>Amit Kumar ha scritto:
> >
> >
> > Hi Massimo,
> >
> > Did you used the raw interface?
> >
> > Is your command looks like -
> > ipmitool -vI lan -H <ip address> -U root raw 0x6 0x2
> >
> > Thanks
> > Amit
> >
>
>
>--
> ____ ____ ____ _ _
> / ___)| __ \/ ___)/ /| | Dott. Massimo Gaggero
>| (___ | /\___ \\__ | Expert Software Engineer
> \____)|_|\_\(____/ |_| Advanced Computing and Communications - Distributed
> Computing
>E-mail: [EMAIL PROTECTED] Phone: +39 070 9250 329
>
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Ipmitool-devel mailing list
Ipmitool-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/ipmitool-devel
