If I recall the zigzagged Bev is done in the vertical plane. I have read of couple hams who'd done that, and I don't recall them being terribly impressed or thinking it was worth the effort. I'd suspect that the vertical components would adversely effect the Bev pattern.
Now for a zigzag BOG on the ground, I suspect that it might act like no more than a bunch of small BOG's in series but aimed at least 90 degrees from each other and end up with a much broader beam and also very poor side nulls. At some point I can try to model this in EZNEC but it will be a lot of work to type in for 100 wires or so. I don't claim to know the answer here and I wish you the best of luck if you try it. I do recall about 6 years ago when I put down my first real BOG here in Barrington and my jaw dropped when I quickly realized how good it was. Many in the DX community were quite skeptical, but now BOG's are used all over the world to good effect. So....if you don't try...you don't know for sure. 73 KAZ ----- Original Message ----- From: "Craig Healy" <[EMAIL PROTECTED]> To: "Mailing list for the International Radio Club of America" <[email protected]> Sent: Tuesday, September 18, 2007 11:05 PM Subject: [IRCA] Shorter BOGs >> I can nicely phase southerly QRM..ie made Winnipeg rather dominant on >> 1290 >> etc etc. Unfortunately the longest I can get is about 295 ft or so but > this >> will still be fine for the high end. > > In Victor Misek's book he shows a shortened wire antenna. It was done by > setting it out in a zigzag fashion. The wire length was pretty long, but > it > didn't take as much real estate. If the BOG were run in a zigzag fashion > across the field, I wonder if it would approximate a longer antenna? > Another way might be to use cotton clothesline rope. Then just loop the > wire up so some sagged down. Probably could get a thousand feet of wire > in > a couple hundred feet or so of land. Loaded antennas are common in > verticals, so maybe the same sort of thing could work in a horizontal > wire. > > Craig Healy > Providence, RI > _______________________________________________ IRCA mailing list [email protected] http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: [email protected]
