Hi,
these are some questions and ISS official answers:
---------------------------------------------------------------
>> In the "Strategy Guide Version 2.0" I see the "Diagram of large deployment
>> model" with a Security Fusion Module on a dedicated server.
>> Is this correct?
Fusion 2.0 will require its own dedicated server. You can view the preliminary
system requirements for Fusion 2.0 at
http://documents.iss.net/literature/SiteProtector/sfm2.0PreliminarySystemRequirements.pdf
>>Instead in the System Requirements Version 2.0, January 28, 2003 pag. 12 :
>>"The impact correlation component of the security fusion module resides on
>>the event collector....".
Fusion 1.2 was an add-on to the Event Collector. Until 2.0 is released if you
wish to use Fusion you will need to install it on each Event Collector you are
using.
---------------------------------------------------------------
Lorenzo
-----Messaggio originale-----
Da: Wassim Nakadi [mailto:[EMAIL PROTECTED]]
Inviato: venerdì 28 marzo 2003 8.37
A: Jones, Jeff; [EMAIL PROTECTED]
Oggetto: RE: [ISSForum] RS Fusion Module
Yes Jeff,
We only need one.
So now i think the best thing to do is to install on the same machine and wait for the new version to come.
but i guess ihave to Check with ISS support first as Mr. Matthew brown said.
-----Original Message-----
From: Jones, Jeff [mailto:[EMAIL PROTECTED]]
Sent: Friday, March 28, 2003 4:40 AM
To: 'Peter Sundstrom'; Wassim Nakadi; [EMAIL PROTECTED]
Subject: RE: [ISSForum] RS Fusion Module
yeah but do you have to have a separate fusion module for every sensor? I
thought you only needed 1?
-----Original Message-----
From: Peter Sundstrom [mailto:[EMAIL PROTECTED]]
Sent: Thursday, March 27, 2003 4:58 PM
To: Wassim Nakadi; [EMAIL PROTECTED]
Subject: RE: [ISSForum] RS Fusion Module
The new Fusion Module that requires to be run on a separate server is not
yet available.
The current Fusion Module runs on the Event Collector.
-----Original Message-----
From: Wassim Nakadi [mailto:[EMAIL PROTECTED]]
Sent: Thu 27/03/2003 12:44 AM
To: [EMAIL PROTECTED]
Cc:
Subject: [ISSForum] RS Fusion Module
Hi everyone,
i have a setup of:
1- SiteProtector (Single machine)
2- 3 Net. Sensors
4- 10 Server Sensors
5- 25 Desktop agents.
6- 50 internet scanner
7- 50 Fusion modules
8- 10 System Scanner agents
I am planning the Hardware requirements for the SiteProtector.
However i am a bit confused about the Fusion Module.
after going over the System requirements sheet. i found out that i
need a dedicated machine for the Attack Patterm component.
Does this apply to my small setup?
And as for the System scanner console, is it possible to install it
on the same machine hosting the SiteProtector.
Thanks in advance,
/WN
_______________________________________________
ISSForum mailing list
[EMAIL PROTECTED]
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to
https://atla-mm1.iss.net/mailman/listinfo
_______________________________________________
ISSForum mailing list
[EMAIL PROTECTED]
TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo
