If they use all the same policy, you can put the parameter in the policy (and not in the advanced parameters of the properties). Afterwards you right-click on the site, Network Protection -> Network Sensor -> Apply Policy.
Another way is to modify the policy via Sensor -> Manage -> Policy... Once your policy has been modified, you have to apply it before saving, hence all sensors using it will be updated. Hope it helps. Jean Paul -----Original Message----- From: [EMAIL PROTECTED] On Behalf Of InfoSec Sent: Tuesday, June 22, 2004 11:01 PM To: [EMAIL PROTECTED] Subject: [ISSForum] Adjusting PAM settings by group? Is there a way to make a PAM setting apply to more than one sensor at a time? Basically all I see is right click in Site Protector on a single sensor (network or appliance) and go to edit properties, hit the last tab and add your parameter. I'd like to adjust say 15+ at a time. Say for instance my gig network flies like it rightfully should, then I want to mod pam.tcp.network.scan.interval But I have 30 sensors that run around these areas, do I have to hit each sensor one at a time to add that pam setting? I don't see it possible in the policy file, but maybe I'm missing something? Thanks, Erin _______________________________________________ ISSForum mailing list [EMAIL PROTECTED] TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo/issforum To contact the ISSForum Moderator, send email to [EMAIL PROTECTED] The ISSForum mailing list is hosted and managed by Internet Security Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328. _______________________________________________ ISSForum mailing list [EMAIL PROTECTED] TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo/issforum To contact the ISSForum Moderator, send email to [EMAIL PROTECTED] The ISSForum mailing list is hosted and managed by Internet Security Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
