[
https://issues.apache.org/jira/browse/TEZ-3718?page=com.atlassian.jira.plugin.system.issuetabpanels:comment-tabpanel&focusedCommentId=16045142#comment-16045142
]
Zhiyuan Yang commented on TEZ-3718:
-----------------------------------
Thanks [~sseth] for review! Doing it the other way around makes sense as our
event should be more like message than command. I'll change the patch for that.
About TaskAttempt configuration, that's for allowing user to fall back to
original behavior and TaskAttempt has to check it. For not accessing
nodeTracker from TaskAttempt, are you suggesting notifying TaskAttempt about
node health? That would be more overhead than pulling info from node tracker
since every TaskAttempt need note down the node health status.
> Better handling of 'bad' nodes
> ------------------------------
>
> Key: TEZ-3718
> URL: https://issues.apache.org/jira/browse/TEZ-3718
> Project: Apache Tez
> Issue Type: Improvement
> Reporter: Siddharth Seth
> Assignee: Zhiyuan Yang
> Attachments: TEZ-3718.1.patch
>
>
> At the moment, the default behaviour in case of a node being marked bad is to
> do nothing other than not schedule new tasks on this node.
> The alternate, via config, is to retroactively kill every task which ran on
> the node, which causes far too many unnecessary re-runs.
> Proposing the following changes.
> 1. KILL fragments which are currently in the RUNNING state (instead of
> relying on a timeout which leads to the attempt being marked as FAILED after
> the timeout interval.
> 2. Keep track of these failed nodes, and use this as input to the failure
> heuristics. Normally source tasks require multiple consumers to report
> failure for them to be marked as bad. If a single consumer reports failure
> against a source which ran on a bad node, consider it bad and re-schedule
> immediately. (Otherwise failures can take a while to propagate, and jobs get
> a lot slower).
> [~jlowe] - think you've looked at this in the past. Any thoughts/suggestions.
> What I'm seeing is retroactive failures taking a long time to apply, and
> restart sources which ran on a bad node. Also running tasks being counted as
> FAILURES instead of KILLS.
--
This message was sent by Atlassian JIRA
(v6.3.15#6346)