Andy,
if you look at the code of Wayland / Weston including in Tizen
Common and IVI you will notice that quite a few change have happen
since 1.4.
The current Tizen Application Manager has not been tested which
that old release and I am sorry to say that I do not know anyone
that is likely going to do so.
You also need to look at the way the security works as Tizen
requires a strict control of how the application are launched and
access to the graphic sub system.
My advise would be that you align you Weston with the last IVI
available, in order for you to be able to benefit from the support
of the engineers working on the project.
Dominig ar Foll
Senior Software Architect
Open Source Technology Centre
Intel SSG
Le 17/09/2014 11:57, Yang Andy a écrit :
Hi Schaufler
I can launch weston,and run EGL-APP in wayland terminal.
So i think weston is installed correctly.
Best regards.
Andy
From: [email protected]
To: [email protected]; [email protected]
CC: [email protected]; [email protected]
Subject: RE: [TizenCommon]Crosswalk launch failed
Date: Tue, 16 Sep 2014 13:12:17 +0000
Yes.
If you have not installed your version of weston
correctly it could cause any number of problems.
Hi
Mikko
>What is the hardware you're using?
VTC1010.
But i customize TizenCommon image,i use weston1.4.
Is there any possibility that weston will result in
crosswalk launch fail?
Best regards.
Andy
Date:
Thu, 11 Sep 2014 13:42:16 +0300
Subject: Re: [TizenCommon]Crosswalk launch failed
From: [email protected]
To: [email protected]
CC: [email protected];
[email protected];
[email protected]
What
is the hardware you're using?
On
Thu, Sep 11, 2014 at 12:20 PM, Yang Andy <[email protected]>
wrote:
Hi
everyone
I tried to use open_app to launch app,it
failed to start up app.
I analyzed the limited error log and
found that process stoped at xwalk
[NavigationControllerImpl::LoadURLWithParams].
Could anyone give me some advice?
[Error Info]
localhost xwalk[548]:
[0911/020431:INFO:navigation_controller_impl.cc(778)]
NavigationControllerImpl::LoadURLWithParams
localhost sh[314]: Couldn't call
'Launch' method:
GDBus.Error:org.freedesktop.DBus.Error.NoReply:
Message did not receive a reply (timeout
by message bus)
localhost sh[314]: launch_application 1
localhost systemd[258]: xwalk.service:
main process exited, code=killed,
status=11/SEGV
localhost systemd[258]: Unit
xwalk.service entered failed state.
Best regards.
Andy
From:
[email protected]
To: [email protected];
[email protected];
[email protected];
[email protected]
Subject: RE: [TizenCommon]Crosswalk
launch failed
Date: Tue, 9 Sep 2014 01:56:17 +0000
Hi
everyone
>Andy please use open_app
binary to start an app.
>open_app <appid>
I tried to use open_app to
launch app,it failed and the
result is the same as using
xwalk-launch.
I analyzed the limited error
log and found that process
stoped at xwalk
[ApplicationService::Launch].
Could anyone give me some
advice?
Best regards.
Andy
_______________________________________________
IVI mailing list
[email protected]
https://lists.tizen.org/listinfo/ivi
|
_______________________________________________
IVI mailing list
[email protected]
https://lists.tizen.org/listinfo/ivi
