Hello, I bought two PVR-150 in Germany. Now i am in Russia and i can't get to work these cards with secam. My source is cable so antenna signal strength is OK!
First i had installed ivtv 0.3.9 and tried to get channels. If card was set to PAL i could get the channel, but the picture was red. If i set tuner to SECAM i didn't even get a picture. Maybe the frequency was not right. But it was the same as with PAL. Then i instaled ivtv 0.4.4. Now when i try to get channel in PAL i get worse picture. Just like the frequency was not exactly right. But if i change frequency i just get even worse picture. If i change to SECAM mode, i get just anomalies in picture. Then i cen't even see what channel is on. Here is my ivtv dmesg [4302412.700000] ivtv: ==================== START INIT IVTV ==================== [4302412.700000] ivtv: version 0.4.4 (tagged release) loading [4302412.700000] ivtv: Linux version: 2.6.12-9-686-smp SMP 686 gcc-3.4 [4302412.700000] ivtv: In case of problems please include the debug info between [4302412.700000] ivtv: the START INIT IVTV and END INIT IVTV lines, along with [4302412.700000] ivtv: any module options, when mailing the ivtv-users mailinglist. [4302412.702000] ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) [4302412.702000] ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 21 (level, low) -> IRQ 21 [4302412.744000] tveeprom: The eeprom says no radio is present, but the tuner type 60 [4302412.744000] tveeprom: indicates otherwise. I will assume that radio is present. [4302412.744000] tveeprom: ivtv version [4302412.744000] tveeprom: Hauppauge: model = 26559, rev = C260, serial# = 2991614 [4302412.744000] tveeprom: tuner = LG S001D MK3 (idx = 60, type = 38) [4302412.744000] tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17) [4302412.744000] tveeprom: audio processor = CX25843 (type = 25) [4302412.744000] tveeprom: decoder processor = CX25843 (type = 1e) [4302412.744000] ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] [4302412.757000] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 [4302412.757000] ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] [4302412.905000] cx25840 1-0044: ivtv driver [4302412.905000] cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) [4302415.616000] cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) [4302415.676000] ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] [4302415.678000] wm8775 1-001b: ivtv driver [4302415.678000] wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0) [4302415.685000] ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] [4302415.697000] tda9887 1-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0) [4302415.697000] ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43] [4302416.379000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) [4302416.589000] ivtv0: Encoder revision: 0x02050032 [4302416.589000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) [4302416.591000] ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) [4302416.592000] ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) [4302416.593000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) [4302416.594000] ivtv0: Create encoder radio stream [4302416.595000] tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by ivtv i2c driver #0 [4302416.809000] ivtv0: Initialized WinTV PVR 150, card #0 [4302416.809000] ivtv: ====================== NEXT CARD ====================== [4302416.809000] ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) [4302416.809000] ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 22 (level, low) -> IRQ 22 [4302416.848000] tveeprom: The eeprom says no radio is present, but the tuner type 60 [4302416.848000] tveeprom: indicates otherwise. I will assume that radio is present. [4302416.848000] tveeprom: ivtv version [4302416.848000] tveeprom: Hauppauge: model = 26559, rev = C260, serial# = 2991594 [4302416.848000] tveeprom: tuner = LG S001D MK3 (idx = 60, type = 38) [4302416.848000] tveeprom: tuner fmt = PAL(B/G) PAL(I) SECAM(L/L') PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17) [4302416.848000] tveeprom: audio processor = CX25843 (type = 25) [4302416.848000] tveeprom: decoder processor = CX25843 (type = 1e) [4302416.848000] ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] [4302416.859000] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 [4302416.859000] ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] [4302417.007000] cx25840 2-0044: ivtv driver [4302417.007000] cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) [4302419.714000] cx25840 2-0044: loaded v4l-cx25840.fw firmware (14264 bytes) [4302419.774000] ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] [4302419.775000] wm8775 2-001b: ivtv driver [4302419.775000] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #1) [4302419.782000] ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] [4302419.793000] tda9887 2-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #1) [4302419.793000] ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] [4302420.475000] ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) [4302420.685000] ivtv1: Encoder revision: 0x02050032 [4302420.686000] ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) [4302420.687000] ivtv1: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) [4302420.689000] ivtv1: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) [4302420.691000] ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) [4302420.695000] ivtv1: Create encoder radio stream [4302420.695000] tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by ivtv i2c driver #1 [4302420.914000] ivtv1: Initialized WinTV PVR 150, card #1 [4302420.914000] ivtv: ==================== END INIT IVTV ==================== _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
