Hi!
Excuse for my bad English.
At me a problem with tv-tuner ( GotView dvd3 Hybrid )
$ lspci -v
02:01.0 Multimedia video controller: Conexant Systems, Inc. CX23418 Single-Chip
MPEG-2 Encoder with Integrated Analog Video/Broadcast Audio Decoder
Subsystem: Device 5854:3343
Flags: bus master, medium devsel, latency 32, IRQ 5
Memory at f0000000 (32-bit, non-prefetchable) [size=64M]
Capabilities: <access denied>
Kernel modules: cx18
$ cat syslog | grep cx18
[18567.790881] cx18: Start initialization, version 1.2.0
[18567.790948] cx18-0: Initializing card 0
[18567.790957] cx18-0: Unknown card: vendor/device: [14f1:5b7a]
[18567.790962] cx18-0: subsystem vendor/device: [5854:3343]
[18567.790966] cx18-0: Defaulting to Hauppauge HVR-1600 card
[18567.790969] cx18-0: Please mail the vendor/device and subsystem
vendor/device IDs and what kind of
[18567.790972] cx18-0: card you have to the ivtv-devel mailinglist
(www.ivtvdriver.org)
[18567.790975] cx18-0: Prefix your subject line with [UNKNOWN CX18 CARD].
[18567.791152] alloc irq_desc for 21 on node -1
[18567.791157] alloc kstat_irqs on node -1
[18567.791169] cx18 0000:02:01.0: PCI INT A -> GSI 21 (level, low) -> IRQ 21
[18567.791182] cx18-0: Unreasonably low latency timer, setting to 64 (was 32)
[18567.793186] cx18-0: cx23418 revision 01010000 (B)
[18568.014713] tveeprom 2-0050: Encountered bad packet header [56]. Corrupt or
not a Hauppauge eeprom.
[18568.014718] cx18-0: Invalid EEPROM
[18568.014723] cx18-0: Simultaneous Digital and Analog TV capture supported
[18568.109388] IRQ 21/cx18-0: IRQF_DISABLED is not guaranteed on shared IRQs
[18568.127167] tuner 3-0061: chip found @ 0xc2 (cx18 i2c driver #0-1)
[18568.150549] cs5345 2-004c: chip found @ 0x98 (cx18 i2c driver #0-0)
[18568.161579] cx18-0: Registered device video1 for encoder MPEG (64 x 32 kB)
[18568.161587] DVB: registering new adapter (cx18)
[18568.176519] cx18 0000:02:01.0: firmware: requesting v4l-cx23418-cpu.fw
[18568.218450] s5h1409_readreg: readreg error (ret == -6)
[18568.218610] cx18-0: frontend initialization failed
[18568.221294] cx18-0: DVB failed to register
[18568.221878] cx18-0: Registered device video33 for encoder YUV (16 x 128 kB)
[18568.222492] cx18-0: Registered device vbi1 for encoder VBI (20 x 51984
bytes)
[18568.223107] cx18-0: Registered device video25 for encoder PCM audio (256 x
4 kB)
[18568.223745] cx18-0: Registered device radio1 for encoder radio
[18568.226287] cx18-0: Error -1 registering devices
[18568.339435] cx18-0: loaded v4l-cx23418-cpu.fw firmware (158332 bytes)
[18568.396446] cx18-0: Error -1 on initialization
[18568.396487] cx18: probe of 0000:02:01.0 failed with error -1
[18568.398513] cx18: End initialization
I have viewed archive of mailing and have found one message with the same
problem
(http://ivtvdriver.org/pipermail/ivtv-devel/2010-April/006519.html),
but haven't found the answer to it.
Prompt, whether there was a decision of this problem?
Best regards.
_______________________________________________
ivtv-devel mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-devel
