Anthony Mittaz wrote: >Hello, I recently bought an Hauppauge WinTV PVR 150(not mce) on ebay and I >couldnt' get it work on my mythtvbackend. I'm also using a wintv pvr 250 >who is working like a charm... > >Here is my init dmesg > <snip>
> PVR 150!!! > >ivtv: Autodetected WinTV PVR 150 card >ivtv: Found an iTVC16 based chip >ACPI: PCI Interrupt Link [LNK2] enabled at IRQ 12 >PCI: setting IRQ 12 as level-triggered >ACPI: PCI interrupt 0000:01:09.0[A] -> GSI 12 (level, low) -> IRQ 12 >ivtv: Unreasonably low latency timer, setting to 64 (was 32) >ivtv: XXX PCI device: 0x01e0 vendor: 0x10de >ivtv: i2c attach [client=tveeprom,ok] >tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 >ivtv: i2c attach [client=(tuner unset),ok] >saa7115: starting probe for adapter ivtv i2c driver #1 (0x10005) >msp3400: error while reading chip version >dont like that > > It's fine, the 150's don't have an msp34XX chip on them >tveeprom: Hauppauge: model = 26034, rev = C197, serial# = 7768178 >tveeprom: tuner = <unknown> (idx = 97, type = 0) >dont like that > > Yes, that's bad. It means you need a newer tveeprom module, and probably a newer tuner module. Try using the ones from ivtv. There has been a lot of work put into bringing these up to speed lately. >tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x44, v4l2 = 0x00000e07) >tveeprom: audio_processor = MSP3400C (type = 4) >ivtv: Tuner Type 0, Tuner formats 0x00000e07, Radio: yes, Model >0x008d1657, Revision 0xe09c25eb >ivtv: Radio detected >ivtv: ivtv_enc_thread: pid = 1972, itv = 0xe09a3120 >cx25840: starting probe for adapter ivtv i2c driver #0 (0x10005) >cx25840: starting probe for adapter ivtv i2c driver #1 (0x10005) >cx25840: detecting client on address 0x88 >cx25840: writing init values >cx25840: FW image '/lib/modules/HcwMakoA.ROM' of size 14264 loaded. >cx25840: FW image md5 digest: 3a4803384f749d644ee1f1ca9dcb12fa >cx25840: FW image sha1 digest: 2b5e6292b7391c980b93d156cf6b34178ce770f6 >cx25840: Status: cx258423 (DEVICE_ID) >ivtv: i2c attach [client=cx25840[50],ok] >ivtv: i2c attach [client=wm8775[50],ok] >ivtv: Encoder revision: 0x02040011 >ivtv: Configuring WinTV PVR 150 card with 5 streams >ivtv: Registered v4l2 device, streamtype 0 minor 1 >ivtv: Create DMA stream 0 using 1024 16384 byte buffers 0 kbytes total >ivtv: Allocate DMA stream 0 using 1024 16384 byte buffers 16777216 kbytes >total >ivtv: Registered v4l2 device, streamtype 1 minor 33 >ivtv: Create DMA stream 1 >ivtv: Allocate DMA stream 1 >ivtv: Registered v4l2 device, streamtype 2 minor 225 >ivtv: Create DMA stream 2 using 121 34632 byte buffers 0 kbytes total >ivtv: Allocate DMA stream 2 using 121 34632 byte buffers 4194304 kbytes >total >ivtv: Registered v4l2 device, streamtype 3 minor 25 >ivtv: Create DMA stream 3 using 455 4608 byte buffers 0 kbytes total >ivtv: Allocate DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total >ivtv: Registered v4l2 device, streamtype 4 minor 65 >ivtv: Create stream 4 >ivtv: Allocate stream 4 >ivtv: Setting Tuner 50 >tuner: type set to 50 (TCL 2002N) by ivtv i2c driver #1 >cx25840: decoder set input (6) >cx25840: Tuner Input >cx25840: set audio: 0x01 >ivtv: Switching standard to PAL. >ivtv: i2c client addr: 0x43 not found! >cx25840: decoder set norm PAL >cx25840: set audio: 0x01 >ivtv: Initialized WinTV PVR 150, card #1 >ivtv: ==================== END INIT IVTV ==================== > > > >modprobe.conf ># ivtv modules videodev >alias char-major-81 videodev >alias char-major-81-0 ivtv >alias char-major-81-1 ivtv >#alias tveeprom tveeprom-ivtv >#alias msp3400 msp3400-ivtv ># Pal user >options cx25840 no_black_magic=1 >options ivtv ivtv_std=2 tuner=5,50 tda9887=0,0 >#options ivtv ivtv_std=2 tda9887=0 >#lircd >install lirc_i2c /sbin/modprobe ivtv; /sbin/modprobe --ignore-istall lirc_i2c > > You may also want to trim this down to just the alias lines. The latest versions should do a fairly good job of auto detecting everything. >Thanks a lot >anthony > > > ------------------------------------------------------- SF.Net email is sponsored by: Tell us your software development plans! Take this survey and enter to win a one-year sub to SourceForge.net Plus IDC's 2005 look-ahead and a copy of this survey Click here to start! http://www.idcswdc.com/cgi-bin/survey?id=105hix _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
