I think the firmware isn't under /lib/modules/ Thanks, Chris On Tue, May 24, 2005 at 09:07:26AM -0400, Hilary L Hertzoff wrote: > I've been running IVTV on SuSE 9.2 for about 6-8 months. > > Now on a new install of 9.3 on a new harddrive, I'm running into problems. > None of the other hardware has changed. > > I've tried using the included IVTV package, reinstalling the package, > upgrading to the latest tarball, reinstalling the firmware, copying over my > modprobe files from the old installation, replacing the firmware files with > newly extracted ones and with the ones from the old installation. > > None of this has fixed the problem. When I run modprobe IVTV I get the > following messages. Everything seems to be fine, but it's not finding the > firmware (which is in the same place as it was in the old install). > > Any thoughts? > > Thanks > Hilary > > May 24 09:05:59 linux kernel: ivtv: ==================== START INIT IVTV > ==================== > May 24 09:05:59 linux kernel: ivtv: version 0.3.2 (c) loading > May 24 09:05:59 linux kernel: ivtv: Linux version: 2.6.11.4-20a-default > gcc-3.3 > May 24 09:05:59 linux kernel: ivtv: In case of problems please include the > debug info > May 24 09:05:59 linux kernel: ivtv: between the START INIT IVTV and END INIT > IVTV lines when > May 24 09:05:59 linux kernel: ivtv: mailing the ivtv-devel mailinglist. > May 24 09:05:59 linux kernel: ivtv: Autodetected WinTV PVR 250 card > May 24 09:05:59 linux kernel: ivtv: Found an iTVC16 based chip > May 24 09:05:59 linux kernel: ACPI: PCI interrupt 0000:00:08.0[A] -> GSI 19 > (level, low) -> IRQ 185 > May 24 09:05:59 linux kernel: ivtv: VIA PCI device: 0x3188 vendor: 0x1106 > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (0) scl=1, sda=1 > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (1) scl=1, sda=0 > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (2) scl=1, sda=1 > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (3) scl=0, sda=1 > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (4) scl=1, sda=1 > May 24 09:05:59 linux kernel: i2c-algo-bit.o: ivtv i2c driver #0 passed test. > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=tveeprom,ok] > May 24 09:05:59 linux kernel: tuner: chip found at addr 0xc2 i2c-bus ivtv i2c > driver #0 > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=(tuner unset),ok] > May 24 09:05:59 linux kernel: saa7115: starting probe for adapter ivtv i2c > driver #0 (0x10005) > May 24 09:05:59 linux kernel: saa7115: detecting saa7115 client on address > 0x42 > May 24 09:05:59 linux kernel: saa7115: writing init values > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=saa7115[6],ok] > May 24 09:05:59 linux kernel: saa7115: status: (1E) 0x48, (1F) 0xc0 > May 24 09:05:59 linux kernel: msp34xx: init: chip=MSP3445G-B8 +nicam +simple > +simpler +radio mode=simple > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=MSP3445G-B8,ok] > May 24 09:05:59 linux kernel: msp3410: daemon started > May 24 09:05:59 linux kernel: tveeprom: Hauppauge: model = 32062, rev = B185, > serial# = 7363116 > May 24 09:05:59 linux kernel: tveeprom: tuner = TCL 2002N 6A (idx = 85, type > = > 50) > May 24 09:05:59 linux kernel: tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, > v4l2 = 0x00001000) > May 24 09:05:59 linux kernel: tveeprom: audio_processor = MSP3445 (type = 12) > May 24 09:05:59 linux kernel: ivtv: Tuner Type 50, Tuner formats 0x00001000, > Radio: yes, Model 0x00891615, Revision 0x80344736 > May 24 09:05:59 linux kernel: ivtv: NTSC tuner detected > May 24 09:05:59 linux kernel: ivtv: Radio detected > May 24 09:05:59 linux udevd[2303]: move seq 1129 with timeout 10 to exec queue > May 24 09:05:59 linux kernel: ivtv: requesting firmware > May 24 09:06:00 linux udevd[2303]: move seq 1130 with timeout 10 to exec queue > May 24 09:06:00 linux kernel: ivtv: firmware load failed > May 24 09:06:00 linux kernel: ivtv: failed loading encoder firmware > May 24 09:06:00 linux kernel: ivtv: Error loading firmware -3! > May 24 09:06:00 linux kernel: ivtv: Error -3 initializing firmware. > May 24 09:06:00 linux kernel: ivtv: Error -12 on initialization > May 24 09:06:00 linux kernel: ivtv-iTVC15_16_mpg2_encoder_card: probe of > 0000:00:08.0 failed with error -12 > May 24 09:06:00 linux kernel: ivtv: ==================== END INIT IVTV > ================ > > > ------------------------------------------------------- > This SF.Net email is sponsored by Oracle Space Sweepstakes > Want to be the first software developer in space? > Enter now for the Oracle Space Sweepstakes! > http://ads.osdn.com/?ad_id=7412&alloc_id=16344&op=click > _______________________________________________ > ivtv-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/ivtv-devel
-- --- Chris Kennedy / [EMAIL PROTECTED] Engineer KMOS-TV/KTBG-FM Broadcasting Services Department Central Missouri State University ------------------------------------------------------- This SF.Net email is sponsored by Yahoo. Introducing Yahoo! Search Developer Network - Create apps using Yahoo! Search APIs Find out how you can build Yahoo! directly into your own Applications - visit http://developer.yahoo.net/?fr=offad-ysdn-ostg-q22005 _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
