try to add the following line in your modprobe.conf
options ivtv ivtv_std=2 tda9887=0 # THIS IS FOR PAL, ADJUST FOR NTSC (STD=1)
Gr
Patrick
________________________________
Van: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Namens Steve Nuffer
Verzonden: zaterdag 25 juni 2005 7:38
Aan: ivtv-devel@lists.sourceforge.net
Onderwerp: [ivtv-devel] PVR-350 TV Out Problem
I just purchased a PVR-350. I'm using FedoraCore3 and have been
following the Redhat Guide.
Receiving static similiar to
http://www.bodgit-n-scarper.com/pvr350.jpg
When I "dd" a mpg file to video16, the output shows but only
briefly. A 6 second file shows for one second or so. I have verified all
connections for the coax input to make sure there working.
# cat /etc/modprobe.conf
alias eth0 3c59x
alias snd-card-0 snd-ens1371
options snd-card-0 index=0
install snd-ens1371 /sbin/modprobe --ignore-install snd-ens1371 &&
/usr/sbin/alsactl restore >/dev/null 2>&1 || :
remove snd-ens1371 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ;
}; /sbin/modprobe -r --ignore-remove snd-ens1371
alias usb-controller uhci-hcd
# ivtv modules setup
alias char-major-81 videodev
alias char-major-81-0 ivtv
alias tveeprom tveeprom-ivtv
install ivtv /sbin/modprobe --ignore-install ivtv; /sbin/modprobe
ivtv-fb
# output of messages
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.2.0 (rc3j) loading
ivtv: Linux version: 2.6.11-1.27_FC3 686 REGPARM 4KSTACKS gcc-3.4
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv: Autodetected WinTV PVR 350 card
ivtv: Found an iTVC15 based chip
PCI: Found IRQ 5 for device 0000:00:11.0
PCI: Sharing IRQ 5 with 0000:00:0d.0
ivtv: XXX PCI device: 0x7190 vendor: 0x8086
tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv: i2c attach [client=(tuner unset),ok]
saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005)
saa7115: detecting saa7115 client on address 0x42
saa7115: writing init values
ivtv: i2c attach [client=saa7115[6],ok]
saa7115: status: (1E) 0x48, (1F) 0xc0
msp34xx: init: chip=MSP3448W-A2 +nicam +simple +simpler +radio
mode=simple
ivtv: i2c attach [client=MSP3448W-A2,ok]
msp3410: daemon started
msp3400: error while reading chip version
saa7127: detecting saa7127 client on address 0x88
saa7127: Selecting NTSC video Standard
saa7127: Selecting S-Video+Composite
saa7127: Turn WSS off
saa7127: Widescreen Mode 4:3 Full Format
saa7127: Selecting Normal Encoder Input
saa7127: Enable Video Output
ivtv: i2c attach [client=saa7127[6],ok]
tveeprom: Hauppauge: model = 48132, rev = K268, serial# = 7875964
tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = MSP3440 (type = 11)
ivtv: i2c attach [client=tveeprom[3],ok]
ivtv: Tuner Type 47, Tuner formats 0x000 01000, Radio: yes, Model
0x00ad2598, Re
vision 0x00000001
ivtv: NTSC tuner detected
ivtv: Radio detected
ivtv: Encoder revision: 0x02040024
ivtv: Encoder Firmware may be buggy, use version 0x02040011
ivtv: Decoder revision: 0x02020023
ivtv: Configuring WinTV PVR 350 card with 9 streams
ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304
kbytes total
ivtv: Registered v4l2 device, streamtype 0 minor 0
ivtv: Create DMA stream 1
ivtv: Registered v4l2 device, streamtype 1 minor 32
ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes
total
ivtv: Registered v4l2 device, streamtype 2 minor 224
ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152
kbytes total
ivtv: Registered v4l2 device, streamtype 3 minor 24
ivtv: Create stream 4
ivtv: Registered v4l2 device, streamtype 4 minor 64
ivt v: Create DMA stream 5 using 16 65536 byte buffers 1048576
kbytes total
ivtv: Registered v4l2 device, streamtype 5 minor 16
ivtv: Create stream 6 using 1024 2048 byte buffers 262144 kbytes
total
ivtv: Registered v4l2 device, streamtype 6 minor 228
ivtv: Create stream 7
ivtv: Registered v4l2 device, streamtype 7 minor 232
ivtv: Create DMA stream 8
ivtv: Registered v4l2 device, streamtype 8 minor 48
ivtv: Setting Tuner 47
tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0
saa7115: decoder set input (4)
saa7115: now setting Composite input
ivtv: Setting audio matrix to input 3, output 1
ivtv: Switching standard to NTSC.
saa7115: decoder set norm NTSC
ivtv: ivtv_enc_thread: pid = 4616, itv = 0xd4df20a0
ivtv: ivtv_dec_thread: pid = 4617, itv = 0xd4df20a0
saa7115: set audio: 0x01
saa7127: Setti ng Encoder Video Standard
saa7127: Set NTSC Video Mode
saa7127: Selecting NTSC video Standard
ivtv: Initialized WinTV PVR 350, card #0
ivtv: ==================== END INIT IVTV ====================
# ivtvctl --input-detect
check SAA7115 input signal
ioctl: VIDEO_STATUS = Bad
SAA7115 reg[STATUS#1 - 0x1E] = 48
Color Standard (D0-D1): BW/No color
White peak loop (D2): Not activated
Gain value for act.lum. (min) (D3): Limited
Gain value for act.lum. (max) (D4): Not limited
WIPA-mode slow-time constant (D5): Not activated
Horizontal frequency (D6): Unlocked
Field length (D7): Non-standard
SAA7115 reg[STATUS#2 - 0x1F] = c0
Ready for capture (D0): No
Macrovision 7.01 (D1): No
MV Colorstripe burst (D2): No
MV Colorstripe burst type 3 (D3): No
Input signal timebase (D4): Non-stable (VCR)
Field frequency (D5): 50Hz
H & V loops (D6): Unlocked
Interlace (D7): Detected
Thanks for any insight that you may have.
Steve
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
-------------------------------------------------------
SF.Net email is sponsored by: Discover Easy Linux Migration Strategies
from IBM. Find simple to follow Roadmaps, straightforward articles,
informative Webcasts and more! Get everything you need to get up to
speed, fast. http://ads.osdn.com/?ad_id=7477&alloc_id=16492&op=click
_______________________________________________
ivtv-devel mailing list
ivtv-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/ivtv-devel
