On Monday 29 August 2005 10:56, c.corax wrote:
> I've also reported this. I have the same problem with a PVR500 card (no
> other cards). Running with Mplayer with "-x 0" works fine but not with "-x
> 1". The problem is the same on both tuners/encoders.
>
> Tuner:PVR500/PAL
> OS: vmlinuz-2.6.11.9-chw-2 (KnoppMyth R5A16)
>
> Could the problem be due to a non 2.6.13 kernel??
Not likely. It's probably because it is very new code that has not been
extensively tested. I know for a fact that the cx25840 registers are not
correctly set, but I simply do not have the time right now to dive into it.
It's not trivial to figure out the correct values.
Hans
>
> /Corax
>
> > Nick Rosier <[EMAIL PROTECTED]>, Mon, 29 Aug 2005 10:42:58 +0200
> >
> > On 8/29/05, Hans Verkuil <[EMAIL PROTECTED]> wrote:
> > > What are your modprobe.conf settings? Are you setting options with
> > > ivtvctl? Pretty much all changed code is related to VBI support, which
> > > you shouldn't be active normally. Did you perhaps do something with
> > > MythTV VBI settings (if there are any)?
> >
> > Hans,
> >
> > I've also reported this when you released 0.3.7h. I only get the
> > artefacts when enabling embedded vbi. For the moment I only embed it
> > on my 350 which does not suffer from the artefacts. For the 150 I've
> > disabled it (but then I lose WSS signals).
> >
> > N.
-------------------------------------------------------
SF.Net email is Sponsored by the Better Software Conference & EXPO
September 19-22, 2005 * San Francisco, CA * Development Lifecycle Practices
Agile & Plan-Driven Development * Managing Projects & Teams * Testing & QA
Security * Process Improvement & Measurement * http://www.sqe.com/bsce5sf
_______________________________________________
ivtv-devel mailing list
ivtv-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/ivtv-devel
