On 10/22/05, dave sailer <[EMAIL PROTECTED]> wrote: > I've had a setup working with a pvr250 for some time now. I added a > pvr150 card and can't get the tuner set correctly. > > lspci -v > > 0000:01:08.0 Multimedia video controller: Internext Compression Inc > iTVC16 (CX23416) MPEG-2 Encoder (rev 01) > Subsystem: Hauppauge computer works Inc.: Unknown device 8003 > Flags: bus master, medium devsel, latency 64, IRQ 18 > Memory at e0000000 (32-bit, prefetchable) > Capabilities: [44] Power Management version 2 > > 0000:01:0a.0 Multimedia video controller: Internext Compression Inc > iTVC16 (CX23416) MPEG-2 Encoder (rev 01) > Subsystem: Hauppauge computer works Inc.: Unknown device 4801 > Flags: bus master, medium devsel, latency 64, IRQ 16 > Memory at e4000000 (32-bit, prefetchable) > Capabilities: [44] Power Management version 2 > > > > > > > dmesg > ivtv: ==================== START INIT IVTV ==================== > ivtv: version 0.4.0 (tagged release) loading > ivtv: Linux version: 2.6.11-gentoo-r9 SMP preempt K7 gcc-3.3 > ivtv: In case of problems please include the debug info > ivtv: between the START INIT IVTV and END INIT IVTV lines when > ivtv: mailing the ivtv-devel mailinglist. > ivtv0: Autodetected WinTV PVR 150 card (iTVC16 based) > ACPI: PCI interrupt 0000:01:08.0[A] -> GSI 18 (level, high) -> IRQ 18 > ivtv0: Unreasonably low latency timer, setting to 64 (was 32) > ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] > tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 8181626 > tveeprom: tuner = <unknown> (idx = 99, type = -1068812320) > tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) > tveeprom: audio_processor = TDA9850 (type = 3) > tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 > ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] > cx25840 3-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0) > cx25840 3-0044: loaded /lib/modules/HcwMakoA.ROM firmware (14264 bytes) > ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] > wm8775 3-001b: chip found @ 0x36 (ivtv i2c driver #0) > ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] > ivtv0: loading /lib/modules/ivtv-fw-enc.bin > ivtv0: Encoder revision: 0x02050032 > ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) > ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) > ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) > ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB > total) > ivtv0: Create encoder radio stream > tuner: tuner type not set > ivtv0: Initialized WinTV PVR 150, card #0 > ivtv: ====================== NEXT CARD ====================== > ivtv1: Autodetected WinTV PVR 250 card (iTVC16 based) > ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16 > ACPI: PCI interrupt 0000:01:0a.0[A] -> GSI 16 (level, high) -> IRQ 16 > ivtv1: Unreasonably low latency timer, setting to 64 (was 32) > ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] > tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 > ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] > tda9885/6/7: chip found @ 0x86 > ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] > tveeprom: Hauppauge: model = 32552, rev = C168, serial# = 7245920 > tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) > tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) > tveeprom: audio_processor = MSP3440 (type = 11) > saa7115 4-0021: saa7115 found @ 0x42 (ivtv i2c driver #1) > ivtv1: i2c attach to card #1 ok [client=saa7115, addr=21] > msp34xx: init: chip=MSP3448W-B3 +nicam +simple +simpler +radio mode=simple > msp3410: daemon started > ivtv1: i2c attach to card #1 ok [client=MSP3448W-B3, addr=40] > ivtv1: loading /lib/modules/ivtv-fw-enc.bin > ivtv1: Encoder revision: 0x02050032 > ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) > ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) > ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) > ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB > total) > ivtv1: Create encoder radio stream > tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #1 > ivtv1: Initialized WinTV PVR 250, card #1 > ivtv: ==================== END INIT IVTV ==================== > > > > the new card is now the first card detected and dmeg shows that the > tuner is not detected. > > I'm using gentoo portage for the ivtv install, which seems to be pretty > good these days. ivtv verison is ivtv-0.4.0-r2. This installs the > firmware and the checksums match th recommended versions. I had a heck > of a time with the same issue with the original card, but I don't > remember much about how I solved it. I seem to remember it was a > combination of things that are now pretty solid in the kernel, ivtv > drivers and gentoo package.
You seem to be using the kernel tveeprom in stead of the ivtv-version. Check /lib/modules/<kernel>/driver/media/video and make sure there's no tveeprom.ko and tuner.ko there (rename or remove them). N. _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
