Hans Verkuil wrote: > On Sunday 15 January 2006 21:43, Bob Wessen wrote: > >> Please excuse this reply to my own message, but I wanted to add that >> the just released 0.4.2 gives the exact same results. >> > > ivtv is not seeing your card at all. Check with lspci to see if the card > is detected properly. > > Hans > > thanks for the reply, thats what I though at first too, since the first line in the dmesg output is usually something about autodetecting the card. lspci gives:
00:14.0 Multimedia video controller: Internext Compression Inc iTVC15 MPEG-2 Encoder (rev 01) before and after running "modprobe ivtv" It however will *sometimes* not see the card after trying to load the ivtv-fb module (which always fails with the error described below) The only way to get it back when it does go away is to pull the power and card out, wait a minute, then plug it back in. >> Bob Wessen wrote: >> >>> I have used the old ivtv 0.2 branch in the past on a VIA M10000 >>> with a PVR350 using gentoo, due to hardware failure it has been >>> out of action for 8 months. I finally ditched the M10000 in favor >>> of a VIA SP13000. Now can't get seem to get ivtv to work again. I >>> have tried both the gentoo 0.4.0 ebuild in the portage tree and >>> when that did not work tried the 0.4.1 release from ivtvdriver.org. >>> >>> I am using Gentoo 2.6.14-r5 sources. >>> >>> lspci gives >>> 00:14.0 Multimedia video controller: Internext Compression Inc >>> iTVC15 MPEG-2 Encoder (rev 01) >>> >>> The strange part is when I try to insert the ivtv module this >>> output comes up in dmesg, >>> >>> ivtv: ==================== START INIT IVTV ==================== >>> ivtv: version 0.4.1 (tagged release) loading >>> ivtv: Linux version: 2.6.14-gentoo-r5 preempt VIAC3-2 gcc-3.4 >>> ivtv: In case of problems please include the debug info between >>> ivtv: the START INIT IVTV and END INIT IVTV lines, along with >>> ivtv: any module options, when mailing the ivtv-users mailinglist. >>> ivtv: ==================== END INIT IVTV ==================== >>> >>> but nothing else. There used to be a whole lot more in the past, >>> and all other posts I have seen have much more going on. After it >>> has been loaded, there are no errors and everything seems fine, but >>> there are no v4l devices setup and nothing works. >>> >>> When I try to load the ivtv-fb module it gives a message >>> ivtv-osd: ivtv_fb_card_id parameter is out of range (valid range: >>> 0--1) >>> >>> at that point the card sometimes hangs, I can't unload the ivtv-fb >>> driver and *sometimes* after this lspci will no longer report the >>> PVR350 as being there. >>> >>> Anyone seen this or have any throughts as to what I can try next? >>> This was all working in the past... >>> >>> _______________________________________________ >>> ivtv-users mailing list >>> [email protected] >>> http://ivtvdriver.org/mailman/listinfo/ivtv-users >>> >> _______________________________________________ >> ivtv-users mailing list >> [email protected] >> http://ivtvdriver.org/mailman/listinfo/ivtv-users >> > > _______________________________________________ > ivtv-users mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-users > _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
