Hans Verkuil wrote: > >Tune the pvr500 to a known good channel and then run ivtvctl >-d /dev/videoX --log-status. What's the output of that command? Please >use either 0.4.2 or the ivtv from subversion (that's 0.6). >Also remove the ivtv module options. There's no need for them. > > Hans > > > Using version 4.2 on kernel 2.6.12, this is what I get:
[EMAIL PROTECTED] ~ $ ptune.pl -d /dev/video1 -f pal-europe-west -c SE11 Ch.SE11: 231250 3700 [EMAIL PROTECTED] ~ $ ivtvctl -d /dev/video1 --log-status ioctl VIDIOC_LOG_STATUS ok ivtv1: ================= START STATUS CARD #1 ================= cx25840 1-0044: Video signal: present cx25840 1-0044: Detected format: PAL-BDGHI cx25840 1-0044: Detected audio mode: mono cx25840 1-0044: Detected audio standard: no detected audio standard cx25840 1-0044: Audio muted: yes cx25840 1-0044: Audio microcontroller: running cx25840 1-0044: Configured audio standard: automatic detection cx25840 1-0044: Configured audio system: automatic standard and mode detection cx25840 1-0044: Specified standard: PAL-BDGHI cx25840 1-0044: Specified input: Tuner cx25840 1-0044: Specified audio input: Tuner cx25840 1-0044: Specified audioclock freq: 48 kHz cx25840 1-0044: Preferred audio mode: stereo cx25840 1-0044: Selected 65 MHz format: autodetect cx25840 1-0044: Selected 45 MHz format: chroma wm8775 1-001b: Input: default tda9887 1-0043: Data bytes: b=14 c=70 e=09 ivtv1: ================== END STATUS CARD #1 ================== And just to ensure that this isn't specific to this channel I did a for loop over every channel where scantv finds a signal, with the same result as above for each one. Hope this is useful feedback. Regards, Ole Andre Schistad _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
