On Tuesday 17 January 2006 18:35, Ole Andre Schistad wrote:
> Hans Verkuil wrote:
> >Tune the pvr500 to a known good channel and then run ivtvctl
> >-d /dev/videoX --log-status. What's the output of that command?
> > Please use either 0.4.2 or the ivtv from subversion (that's 0.6).
> >Also remove the ivtv module options. There's no need for them.
> >
> >     Hans
>
> Using version 4.2 on kernel 2.6.12, this is what I get:
>
> [EMAIL PROTECTED] ~ $ ptune.pl -d /dev/video1 -f pal-europe-west -c SE11
> Ch.SE11: 231250 3700
> [EMAIL PROTECTED] ~ $ ivtvctl -d /dev/video1 --log-status
> ioctl VIDIOC_LOG_STATUS ok
>    ivtv1: =================  START STATUS CARD #1  =================
>    cx25840 1-0044: Video signal:              present
>    cx25840 1-0044: Detected format:           PAL-BDGHI
>    cx25840 1-0044: Detected audio mode:       mono
>    cx25840 1-0044: Detected audio standard:   no detected audio
> standard cx25840 1-0044: Audio muted:               yes
>    cx25840 1-0044: Audio microcontroller:     running
>    cx25840 1-0044: Configured audio standard: automatic detection
>    cx25840 1-0044: Configured audio system:   automatic standard and
> mode detection
>    cx25840 1-0044: Specified standard:        PAL-BDGHI
>    cx25840 1-0044: Specified input:           Tuner
>    cx25840 1-0044: Specified audio input:     Tuner
>    cx25840 1-0044: Specified audioclock freq: 48 kHz
>    cx25840 1-0044: Preferred audio mode:      stereo
>    cx25840 1-0044: Selected 65 MHz format:    autodetect
>    cx25840 1-0044: Selected 45 MHz format:    chroma
>    wm8775 1-001b: Input: default
>    tda9887 1-0043: Data bytes: b=14 c=70 e=09
^^^^^^^^^^^^^^

These tda9887 values are wrong. Do you have tda9887 options set 
somewhere? The value for 'b' should be 0xd4, if I force the value to 
your setting I also have no sound. 

        Hans

>    ivtv1: ==================  END STATUS CARD #1  ==================
>
>
> And just to ensure that this isn't specific to this channel I did a
> for loop over every channel where scantv finds a signal, with the
> same result as above for each one.
>
> Hope this is useful feedback.
>
> Regards,
>
> Ole Andre Schistad
>
> _______________________________________________
> ivtv-users mailing list
> [email protected]
> http://ivtvdriver.org/mailman/listinfo/ivtv-users

_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users

Reply via email to