David Novick wrote: > --- Tony Chiaffredo <[EMAIL PROTECTED]> wrote: > > >> David Novick wrote: >> >>> --- Tony Chiaffredo <[EMAIL PROTECTED]> wrote: >>> >>> >>> >>>> I'm just not familiar with the debugging steps getting ivtv installed >>>> and configured correctly, and I need some help debugging further. >>>> >>>> I'm trying to get the ivtv-0.4.4 driver installed on my 2.6.15-gentoo-r7 >>>> distribution. My card is still not being recognized in the dmesg output >>>> (below). Also, ivtvctl -a output below that. >>>> >>>> I've been trying to build and install the driver using the Generic >>>> Install Directions (http://www.ivtvdriver.org/index.php/Howto) and >>>> firmware (http://www.ivtvdriver.org/index.php/Firmware)because >>>> ivtv-0.4.2 is the most recent version in Gentoo portage (masked at that). >>>> >>>> TIA, >>>> >>>> TonyC >>>> >>>> >>>> ivtv: ==================== START INIT IVTV ==================== >>>> ivtv: version 0.4.4 (tagged release) loading >>>> ivtv: Linux version: 2.6.15-gentoo-r7 SMP gcc-3.4 >>>> ivtv: In case of problems please include the debug info between >>>> ivtv: the START INIT IVTV and END INIT IVTV lines, along with >>>> ivtv: any module options, when mailing the ivtv-users mailinglist. >>>> ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) >>>> GSI 23 sharing vector 0xE1 and IRQ 23 >>>> ACPI: PCI Interrupt 0000:03:08.0[A] -> GSI 17 (level, low) -> IRQ 225 >>>> ivtv0: Unreasonably low latency timer, setting to 64 (was 32) >>>> tveeprom: Second (radio) tuner idx 101 >>>> tveeprom: ivtv version >>>> tveeprom: Hauppauge: model = 23552, rev = E492, serial# = 9308876 >>>> >>>> >>> The E492 is a newer Samsung model. >>> >>> This person: >>> http://www.gossamer-threads.com/lists/ivtv/users/29089 >>> >>> Had luck using kernel 2.6.16.x and ivtv 0.6.1 >>> http://www.gossamer-threads.com/lists/ivtv/users/29091 >>> >>> >>> David Novick >>> [EMAIL PROTECTED] >>> >>> >>> >> I saw that post, so I figured what the heck. Upgraded to 2.6.16, and >> installed ivtv 0.6.1. >> >> No luck. Anyone? Ideas? >> > > After upgrading to ivtv 0.6.1 did you turn your machine off, and wait at least > 30 seconds? > > > > David Novick > [EMAIL PROTECTED] > Yes, I did. What is the next step to troubleshoot?
So because the dmesg output confirms the driver. I should then concentrate on the firmware. Is this a correct assumption? I followed the firmware directions, but I must have made a mistake. TonyC _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
