Adam, You need to upgrade your firmware for your Hauppauge card. It makes a big difference. For instructions read: http://www.ivtvdriver.org/pipermail/ivtv-users/2006-May/002723.html
Jonathan > I have installed a Hauppauge 500 card. The 1st tuner is working > great. The 2nd tuner displays a good picture, but the sound is just > static. To verify the problem is not with my MythTV config, I tested > by issuing the command "cat /dev/video1 > /tmp/test.mpg". I haven't > found any errors in my logs. Any ideas? > > I'm currently running: > Ubuntu > Kernel 2.6.10-6-386 > ivtv 0.4.5 > > ivtv: ==================== START INIT IVTV ==================== > ivtv: version 0.4.5 (tagged release) loading > ivtv: Linux version: 2.6.10-6-386 preempt 386 gcc-3.3 > ivtv: In case of problems please include the debug info between > ivtv: the START INIT IVTV and END INIT IVTV lines, along with > ivtv: any module options, when mailing the ivtv-users mailinglist. > ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) > ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 11 > PCI: setting IRQ 11 as level-triggered > ACPI: PCI interrupt 0000:02:08.0[A] -> GSI 11 (level, low) -> IRQ 11 > ivtv0: Unreasonably low latency timer, setting to 64 (was 32) > tveeprom: Second (radio) tuner idx 101 > tveeprom: ivtv version > tveeprom: Hauppauge: model = 23552, rev = E587, serial# = 8825862 > tveeprom: tuner = Samsung TCPN 2121P30A (idx = 87, type = 68) > tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) > tveeprom: audio processor = CX25843 (type = 25) > tveeprom: decoder processor = CX25843 (type = 1e) > ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] > ts: Compaq touchscreen protocol output > ivtv0: This is the first unit of a PVR500 > tuner (ivtv): chip found at addr 0xc0 i2c-bus ivtv i2c driver #0 > TEA5767 detected. > ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=60] > tuner: type set to 62 (Philips TEA5767HN FM Radio) by autodetect > type set to 62 (Philips TEA5767HN FM Radio) > tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 > ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] > cx25840 0-0044: ivtv driver > cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0) > cx25840 0-0044: loaded v4l-cx25840.fw firmware (14264 bytes) > ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] > wm8775 0-001b: ivtv driver > wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) > ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] > ivtv0: Detected a TEA5767 radio tuner. Enabling radio support. > ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv0: Encoder revision: 0x02050032 > ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB > total) > ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) > ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) > ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers > (2048KB total) > ivtv0: Create encoder radio stream > tuner: type set to 68 (Samsung TCPN 2121P30A) by ivtv i2c driver #0 > ivtv0: Initialized WinTV PVR 500 (unit #1), card #0 > ivtv: ====================== NEXT CARD ====================== > ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) > ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 11 > ACPI: PCI interrupt 0000:02:09.0[A] -> GSI 11 (level, low) -> IRQ 11 > ivtv1: Unreasonably low latency timer, setting to 64 (was 32) > tveeprom: Second (radio) tuner idx 101 > tveeprom: ivtv version > tveeprom: Hauppauge: model = 23552, rev = E587, serial# = 8825862 > tveeprom: tuner = Samsung TCPN 2121P30A (idx = 87, type = 68) > tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) > tveeprom: audio processor = CX25843 (type = 25) > tveeprom: decoder processor = CX25843 (type = 1e) > ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] > tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 > ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] > cx25840 1-0044: ivtv driver > cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) > cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) > ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] > wm8775 1-001b: ivtv driver > wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) > ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] > ivtv1: This is the second unit of a PVR500 > ivtv1: Correcting tveeprom data: no radio present on second unit > ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv1: Encoder revision: 0x02050032 > ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB > total) > ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) > ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) > ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers > (2048KB total) > tuner: type set to 68 (Samsung TCPN 2121P30A) by ivtv i2c driver #1 > ivtv1: Initialized WinTV PVR 500 (unit #2), card #1 > ivtv: ==================== END INIT IVTV ==================== > > ---- > Adam > >------------------------------------------------------------------------ > >_______________________________________________ >ivtv-users mailing list >[email protected] >http://ivtvdriver.org/mailman/listinfo/ivtv-users > _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
