Hello list.
I would like to loopback the audio signal from my pvr-350 to the onboard
line-in of my soundcard. Problem: I only get noise, also if I take the signal
directly from the cable. I'm using the scart cable that has this small
additional audio loopback plug.
-Sound directly from the TV works (via scart).
-Playing mp3 files or streams work via the onboard soundcard.
-The line-in of the soundcard is ok.
-I tried different versions of ivtv.
Thanks for any reply.
Mike
Setup:
0000:00:14.0 Multimedia video controller: Internext Compression Inc iTVC15
MPEG-2 Encoder (rev 01)
0000:00:11.5 Multimedia audio controller: VIA Technologies, Inc.
VT8233/A/8235/8237 AC97 Audio Controller (rev 50)
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.1 (tagged release) loading
ivtv: Linux version: 2.6.11.7-chw-4 SMP preempt 586 gcc-3.3
ivtv0: Autodetected WinTV PVR 350 card (cx23415 based)
ACPI: PCI interrupt 0000:00:14.0[A] -> GSI 10 (level, low) -> IRQ 10
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0)
msp34xx: init: chip=MSP3418W-B3 +nicam +simple +simpler +radio mode=simple
msp3410: daemon started
ivtv0: i2c attach to card #0 ok [client=MSP3418W-B3, addr=40]
msp3400: error while reading chip version
saa7115 1-0021: ivtv driver
saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21]
saa7127 1-0044: ivtv driver
saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=saa7127, addr=44]
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
tveeprom: Hauppauge: model = 48139, rev = K257, serial# = 7853848
tveeprom: tuner = Philips FM1216 ME MK3 (idx = 57, type = 38)
tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17)
tveeprom: audio_processor = CS5331 (type = 9)
tda9885/6/7: chip found @ 0x86
ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Decoder revision: 0x02020023
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total)
ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total)
ivtv0: Create decoder VOUT stream
ivtv0: Allocate DMA decoder YUV stream: 20 x 51840 buffers (1024KB total)
ivtv0: loaded v4l-cx2341x-init-mpeg.bin firmware (155648 bytes)
tuner 1-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
spurious 8259A interrupt: IRQ7.
ivtv0: Initialized WinTV PVR 350, card #0
ivtv: ==================== END INIT IVTV ====================
--
Bis zu 70% Ihrer Onlinekosten sparen: GMX SmartSurfer!
Kostenlos downloaden: http://www.gmx.net/de/go/smartsurfer
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
