(Dup of problem not yet resolved on mythtv-users list. I realized this is the better place for it.)
I just upgraded my kernel to 2.6.12 and my ivtv to 0.4.5 (via atrpms) but I can't get the tuner to work. The capture is working, though it always remains on one channel (5) and has some audio problems. When I install the driver, I get "tuner 0-0061: tuner type not set" even though the driver is correctly detecting tuner type 50, for this pvr-250 card. It does this even if I install the driver with "modprobe ivtv tuner=50" Here's the output from driver load, even with tuner= option ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.5 (tagged release) loading ivtv: Linux version: 2.6.12-2.3.legacy_FC3smp SMP 686 REGPARM 4KSTACKS gcc-3.4 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected WinTV PVR 250 card (cx23416 based) ACPI: PCI Interrupt 0000:02:04.0[A] -> GSI 18 (level, low) -> IRQ 169 ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] saa7115 0-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21] msp3400 0-0040: MSP3445G-B8 found @ 0x80 (ivtv i2c driver #0) msp3400 0-0040: MSP3445G-B8 supports radio, mode is autodetect and autoselect ivtv0: i2c attach to card #0 ok [client=MSP3445G-B8, addr=40] lirc_i2c: chip found @ 0x18 (Hauppauge IR) ivtv0: i2c attach to card #0 ok [client=Hauppauge IR, addr=18] lirc_dev: lirc_register_plugin: sample_rate: 10 tveeprom 0-0050: Hauppauge model 32062, rev B185, serial# 7476925 tveeprom 0-0050: tuner model is TCL 2002N 6A (idx 85, type 50) tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 0-0050: audio processor is MSP3445 (idx 12) tveeprom 0-0050: decoder processor is SAA7115 (idx 19) tveeprom 0-0050: has no radio, has IR remote ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02040024 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner 0-0061: tuner type not set tuner 0-0061: tuner type not set ivtv0: Initialized WinTV PVR 250, card #0 ivtv: ==================== END INIT IVTV ==================== Thanks for any assist. In modprobe.conf # ivtv modules setup alias char-major-81 ivtv alias char-major-81-0 ivtv options ivtv tuner=50 This is on FC3. _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
